5.0 boltons

  1. D

    Engine Swap to a mechanical oil pressure gauge (1993, 5.0)

    I have a '93 (as best I can tell) 5.0 engine and computer which I have installed in my '66 Mustang. Can I disconnect the electronic oil pressure sender completely and replace it with a flexible stainless braided line for my mechanical gauge and leave it disconnected or is there a required signal...
  2. MeyHam413

    What Next? Throttle Body or Electric Water Pump 2011 5.0 (H-pipe, Axel Back CAi, E85)

    Okay so I’m unsure to what mods I should add next. I live in CA so of course I’m looking for CARB certified parts. Unlike most, the CARB laws don’t bother me as much. I honestly find it fun picking out just the right part to stay legal while staying neck and neck with a 2010-12 GT500, 2016...
  3. T

    15k for upgrades

    I have a 1994 Mustang gt and I want to start putting on some serious performances parts but I don’t know where to start. Suggestions on performance mechanics and performance upgrades are needed! Remember that if you tell me about a mechanic make sure they work near me, I’m from Thousand Oaks...
  4. 1989LXFOX

    Engine SVE Top End Kit Fit Question

    Hello everyone, I had previously posted a thread about SVE heads (which was answered, thank you). After learning that I also had to buy rocker arms, hardened push rods, lifters?, gaskets etc the original spend of $800-900 quickly escalated. I was looking at the SVE top end kit on LMR...
  5. 1989LXFOX

    Engine SVE Aluminum Head Swap Question

    Hello all, I was looking into buying these to put onto my (mostly) stock 302. I ma not planning on racing this car, just ziping around neighborhood. I had a few questions: Can I use the rocker arms off the stock E7 heads? Do I really need hardened push rods? I assume the stock cam will work...
  6. M

    89 Lx Hatchback Mild Mods

    I am a new member gallon 89 Mustang hatchback lx5.0 thats stock I am going to put on the following bolt ons 303 cam ,large shorty headers ,sve942. Intake ,75 millimeter throttle body, 75 millimeter EGR spacer, 76 millimeter mass air flow sensor for 19 pound injectors, and a cold air intake, and...
Top Bottom
Forums
Menu