Hi,
I seated a wheel bearing, the driver was riding on the middle of the bearing case instead of the outer edge, it looks like the bearing case may have flattened a little, but still moves freely.
Also when I seated one axle seal it went in around 1/8” past flush.
Do these issues constitute...
Well I've never posted on a forum , but im a bit confused
I have a 2000 v.6 automatic and recently I've replaced the wheel bearing on the front left tire
After awhile I went to drive it, and it started up just fine but when I shifted into reverse it started shaking from the front wheel area...
03 GT traction lok rear end.
When turning, either direction, the rear makes a muffled grinding sound under acceleration (imagine two stones grinding on each-other in a circular motion), and a whining sound without acceleration (kind of like a dry door hinge but muffled). There is no sound until...
My 1991 Mustang came with an extra pair of 96 SN95 front spindles and hubs. I also have a pair of loaded 94 SN95 spindles with the correctly bent steering arm ends that I will eventually use for bigger, 5 lug brakes.
The questions - are the hubs (with the front wheel bearings) the same, and...