Hello everyone, New to this page here.
I have a 1990 Mustang 5.0 ( manual T-5)
I just replaced the starter with a brand new SVE high torque mini starter from LMR. I also put in a new fender mount solenoid.
When I go to start the car, it makes a loud rubbing / grinding noise. It’s not the same...
I'm having some trouble with my new microsquirt install. Setup is a stock 302 with a mild cam (I'm guessing e303) and 1.7 rockers. I was able to get it running yesterday and it fired up several times no problem and ran very smoothly. I started messing with the idle and calibrated the tps, but...
I have a 1993 5.0 gt just done trick flow upper lower intake, 75mm throttle body, 76mm bbk maf, 30lb injectors, 255lph fuel pump, x303 cam, trick flow 170cc aluminum head 61cc combustion chamber, 1.6 roller rockers and bored .30 over bbk shorty headers and xpipe and other odds and ends.
The...
Run down of the car: 88 Mustang GT Hatch w/ sun roof; stock as far as I know besides the cold air intake (non MAF)
Had my car sit for about a week. Went to start it one morning backed out a bit, put it in drive and it died. Haven’t been able to get it started since. It’ll turn over and then...