gasket

Good evening Friends wherever you are, In the process of doing my first rebuild of my 1996 4.6L DOHC for eventual drop back into my '96 street/strip Cobra. My north star/target is a 10.6, 1/4 mile: My recipe is 675HP/600LB/FT @ 3500LBS 4.10 gears, according to the calculator I'm looking at, it...

Hello all! This will be a quick one. I went to Auto zone for a new gas cap, and the guy there offered to take off the old one, which had a bracket on it, which held the gas cap to the car. He asked if I wanted the bracket back on, and I said no because it was broken. HOWEVER. he did not put...

Hello all, I am thinking about purchasing a edelbrock 600 cfm carburetor (part number 1406). I'll be bolting it to the stock intake manifold that came with the original ford 302. The original carburetor was a motorcraft 2150, not sure if that helps. Anyways the question is if I need any gaskets...

I have coolant pooled up under my upper intake manifold near my passenger side valve cover. I recently replaced my thermostat and have a coolant sensor that I still need to put in. I can't tell if it's leaking from a cracked manifold or if it's a bad intake gasket. Which is more likely and how...