Quick build
Stock bottom end 302
trickflow box r intake
harland sharp rockers
V2 on 13lbs of boost
Edelbrock rpm heads
Stock fuel
42lb injectors
Car made 520 wheel, I got it with lower intake leak fixed it. Through brand new autolite 3923 plugs in gapped to .023. Went got tuned and dyno’d very...
So pulled motor and tranny. Eventually going turbo but was trying to maintain somewhat of a budget. Cylinders still look good but motor was filthy. So.... do all seals put it back together or pull it apart and do bearings and rings etc. Cranck has zero play. 87 forged internals.
Hello everyone.
I came today with something odd. I own a 2003 v6 mustang (manual) and as i work on it something that shows constantly is the idea of tuning the car too a higher compression ratio to use high octane gas. This would give the car a little bit more of punch; however, there is always...
ok so i found out i had a chipped piston on my 95 V6 Base Mustang, (my piston is .75mm oversized btw) the ring was bent so i need to get new rings, the problem is, i found the .75mm ring kit but its too expensive for me rn because ive already put hundereds in parts because of the other stuff i...