With current valve cover setup the breather hole is towards back on passenger side. That side is conflicting with the throttle cable in order to install anything. On the driver's side valve cover hole is under intake leaving little room for much at all.
Was looking to see if anyone has come up...
I have a 2007 V6 automatic pony pack Mustang its been in an accident and i am repairing it.
I installed new valve covers and gaskets but i am missing a fastener or screw plate in the passenger side. Behind the spark plug wires there is a hole for what i think is a 7mm bolt I'm Hoping someone...
What up Fellow Stang Owners!
Bought my SN95 a few months ago from my neighbor. May as well have stolen it from them for what I paid. Either way, the car was half dead and barely running. I've done a decent amount on it thus far (tune up, coolant flush, oil change, & rear drums and brake pads)...
Hi All,
Wondering what the steps are to remove the P1SC head unit on a 09 mustang. Basically I just purchased the Ford Racing valve covers/gaskets. To remove the drivers side valve cover, it "appears" I will need to remove the head unit of the procharger as it sits almost right on the outer...