• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

1989 Fox 5.0 Clutch issues?

  • Thread starter Thread starter 89darthvador
  • Start date Start date Jan 7, 2011
8

89darthvador

New Member
Jan 1, 2011
8
0
0
Jan 7, 2011
#1
  • Jan 7, 2011
  • #1
Problem.. When you let off the clutch and push one the gas in first its like your trying to granny shift from third. Oil pressure and battery bog down. Same thing in second.. Get into third no problems.. Then you smell a burning wire/rubber scent. Wierd is its not all the time.. Any ideas?? Thanks
 

Noobz347

Stangnet Facilities Maint Tech... Er... Janitor
Admin Dude
Jan 4, 1985
43,012
21,194
234
Box behind Walmart
Jan 7, 2011
#2
  • Jan 7, 2011
  • #2
Please re-describe the problem in better detail.
 
8

89darthvador

New Member
Jan 1, 2011
8
0
0
Jan 7, 2011
#3
  • Jan 7, 2011
  • #3
when in first and you let off the clutch and start to move it acts like its going to die almost. Same thing in second gear.. Once you get to third its fine. after it starts you smell it really bad.. and it doesnt happen all the time.. took it to a transmission shop today and he says its probably the pressure plat..
 

Noobz347

Stangnet Facilities Maint Tech... Er... Janitor
Admin Dude
Jan 4, 1985
43,012
21,194
234
Box behind Walmart
Jan 7, 2011
#4
  • Jan 7, 2011
  • #4
Is the clutch "grabby" when you try to start out slow?

Is it hard to get the shifter into gear?

What clutch cable and quadrant are you running?

On a flat surface, with the car is 1st gear and the clutch pushed in normally (not jammed as far to the floor as you can get it), does the car creep forward at all?

Do you have a rough time finding reverse on a normal basis?
 
8

89darthvador

New Member
Jan 1, 2011
8
0
0
Jan 10, 2011
#5
  • Jan 10, 2011
  • #5
yes the clutch will grab and begain to roll.. at times its kinda hard to get it into first and reverse... not sure on the clutch cable.. just bought this car..
 
You must log in or register to reply here.

Similar threads

C
Electrical HELP! 1989 5.0 Stick, Voltage Bleed onto Ignition Trigger wire
  • ChickenDeluxe
  • May 14, 2026
  • Fox 5.0 Mustang Tech
Replies
7
Views
210
Fox 5.0 Mustang Tech May 24, 2026
ChickenDeluxe
C
A
1987 5.0 speed density Foxbody crank no start
  • Alan2204
  • May 23, 2026
  • Fox 5.0 Mustang Tech
Replies
10
Views
251
Fox 5.0 Mustang Tech May 30, 2026
Mcmahst
M
85 mustang 5.0 cranking in run position
  • Mamaclean
  • May 23, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
127
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 1, 2026
General karthief
Fox Fuel Pump Issues After Replacement/Upgrade
  • Ryu
  • Jun 23, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
23
Views
520
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 5, 2026
Ryu
8
Engine Rough idle and aggressive sputtering when accelerating
  • 88vertible
  • Aug 13, 2025
  • Fox 5.0 Mustang Tech
Replies
4
Views
1K
Fox 5.0 Mustang Tech Dec 13, 2025
Jarhead67
J
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?