I am installing the wires for my Taylor battery relocation kit, and I can't figure out how the rear seat comes out...the bottom part that is.
Any suggestions would be greatly appreciated as we are in the middle of the install.
~Darren
removing the back seat is very easy. Just lift out the bottom part of the seat ( the area where the ass comes into contact, not the back rest). YOu might have to use some strength but it will pop right out.
removing the back seat is very easy. Just lift out the bottom part of the seat ( the area where the ass comes into contact, not the back rest). YOu might have to use some strength but it will pop right out.
Ok...do I pull up from the front or the back. I have been pulling from the middle of the front near the tranny tunnel hump...is that a good place to lift from?
~Darren
removing the back seat is very easy. Just lift out the bottom part of the seat ( the area where the ass comes into contact, not the back rest). YOu might have to use some strength but it will pop right out.
Well to do it without breaking anything, in the middle of each seat on the bottom section their is a button to puch in with a flat head screw driver which will allow the seat to pop up. Like I said is is located in the middle of the seat (as if you were sitting in the seat, it would be b/w your legs) pull up on the front of the seat and you will see the little button to push in