Hi, looking for some help or suggestions. I am stuck. So i have a 2000 gt, The drivers side windows works fine. I can get and can test for power w/test light at the switch. If i do it w/multimeter i get it with power on up and down. When i go to the switch on the passengers side, I hear nothing, no hum, no click , nothing. First i am new to the electrical stuff, as far as using a multimeter. At the passenger switch, it gets power to the door unlock/lock button, But when i try to test it it doesnt show on test light. but i see a glimpse on multimeter. (i have it set to V, i am wondering if i need to put it to 10amps but, afraid, thinking the output may be to much? When i try to probe the wire at the switch i get nothing. zilch. I thought maybe it was the switch. Changed it. still nothing. The only two wires that are getting power are for the lock. but not for the power window. Is there a way to probe a line to check for power, or do you have to press down on switch to get power non the line? Fuse is fine. I don't believe its the motor, I do not see any power at the switch. By diagrams, all i can tell is its the line from there, and back to the GEM?
I am assuming i might have to bypass it and run a line from where its good to the switch? Does anybody have any suggestions or other ways of checking.
I am using a multimeter 600 klien tools multimeter, with the key in and turned to on, depress switch, I am probing all the lines where the switch is on the passenger side. i get nothing.
I am assuming i might have to bypass it and run a line from where its good to the switch? Does anybody have any suggestions or other ways of checking.
I am using a multimeter 600 klien tools multimeter, with the key in and turned to on, depress switch, I am probing all the lines where the switch is on the passenger side. i get nothing.