• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SVT Tech Forum

2003-2004 Cobra question

  • Thread starter Thread starter ras50gt
  • Start date Start date Mar 12, 2011

ras50gt

Member
Oct 25, 2005
200
2
19
Mar 12, 2011
#1
  • Mar 12, 2011
  • #1
Looking at buying an 03 cobra soon. Went and looked at one the other day and had two guestions.

First- When looking in the truck to the left (driver side) the trunk lining was sticking out a little so I looked behind it. There was a small box looked like wires going into it. What is this? I was thinking maybe fuel inertia switch. He thought possibly abs module, but im pretty sure that would be up front. Anyone with a cobra help me out with this?

Second- we test drove the car for a good ten mins, came back to the parking lot we met at, turned car off. I looked around, inspected a few more things, talked to the owner for a little bit. Then asked him to start the engine again. I was standing driver side with the hood open. As soon as he started the car, I saw some white smoke from the engine bay coming from passenger side firewall area. It last only a few seconds maybe 20 at the most then went away, noticed it coming from bottom passender side right behind left front tire also. After that, I looked couldn't see anything. The owner wasnt sure either and never noticed this. We let car sit, tried again, it never smoked again after that. Any ideas? Can someone tell me where the a/c drain is on a 2003 cobra?

Thanks!!
 

COBRA90GT

Mustang Master
Sep 22, 2001
6,654
0
87
HOCKEYTOWN ® , MI
Mar 13, 2011
#2
  • Mar 13, 2011
  • #2
Sounds like the fuel inertia switch.

If you look again on the left side of the trunk, behind the carpeting, you SHOULD see the fuel inertia cut-off/reset switch. It usually has a red button, with an accompanying wire harness going into it as well. You can probably do a "Google Image" search to find pics of same to confirm whether it was that or not.



Not sure about the smoke - did you have the A/C running during the test drive? If so, it's possible that the condensation (water) from the A/C (evap?) unit is dripping down and "burning" off on the hot/heated passenger side exhaust tubing.

IIRC, I have seen this happen on other mustangs once you shut the car off. But, it shouldn't be a solid white smoke cloud. White clouds of smoke typically indicate coolant (aka: antifreeze) burning off somewhere. Did you notice a "sweet" smell under the hood - typical of coolant/antifreeze burning.


If you inspect the car a 2nd tme, take note of the above and keep it in mind, or have it looked over by a trusted mechanic if you are unsure.

G'luck.
 
0

04cobra1

New Member
Mar 23, 2011
3
0
0
Mar 23, 2011
#3
  • Mar 23, 2011
  • #3
p0190,p1233

bought used 04 terminator,ran good till i put nkg tr6.it stated to miss so i pulled the plugs to find freckled pistons and folded spark plugs so i assume a lean condition is happening.compression check shows an average ag 151psi so i put it all back together started it to find these codes present p0190 and 1233 im a toyota tech with no ford computer to properly diag any clues would be awesome and appreciated
 
0

04cobra1

New Member
Mar 23, 2011
3
0
0
Mar 23, 2011
#4
  • Mar 23, 2011
  • #4
anyone
 

vikingpower

New Member
Dec 6, 2004
656
0
0
CWU Ellensburg, WA
Apr 2, 2011
#5
  • Apr 2, 2011
  • #5
04cobra1 said:
anyone
Click to expand...
all the plugs are bad or only certain cylinders?
 
R

Rad Ray

New Member
Jul 17, 2003
23
0
1
May 4, 2011
#6
  • May 4, 2011
  • #6
No worries. Mine does the same thing and the dealer says it's normal. How much is he asking for purchase?
 

hotcobra03

Active Member
Nov 29, 1999
969
4
39
poteet,tx
May 4, 2011
#7
  • May 4, 2011
  • #7
04cobra1 said:
bought used 04 terminator,ran good till i put nkg tr6.it stated to miss so i pulled the plugs to find freckled pistons and folded spark plugs so i assume a lean condition is happening.compression check shows an average ag 151psi so i put it all back together started it to find these codes present p0190 and 1233 im a toyota tech with no ford computer to properly diag any clues would be awesome and appreciated
Click to expand...

just as good if not better than fsm

Gale Cengage Product Failure
 
You must log in or register to reply here.

Similar threads

68 vert where to start?
  • 67 blueberry
  • Jul 2, 2026
  • 1965 - 1973 Classic Mustangs -General/Talk-
Replies
0
Views
67
1965 - 1973 Classic Mustangs -General/Talk- Jul 2, 2026
67 blueberry
F
2004 Mustang GT – Fuel Pump Not Priming
  • Fayio
  • Apr 22, 2026
  • SN95 4.6L Mustang Tech
Replies
7
Views
319
SN95 4.6L Mustang Tech Apr 27, 2026
n0v8or
N
N
Power door lock motor Question
  • NYFox
  • Mar 15, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
276
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Mar 17, 2026
NYFox
N
Buying with a bad motor?
  • djj62478
  • Mar 8, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
8
Views
303
1996 - 2004 SN95 Mustang -General/Talk- Mar 11, 2026
TTSaleen
R
What's it Worth? 1997 Cobra, a ton of mods and restoration
  • riored97snake
  • Jun 18, 2026
  • What is it Worth?!?!?
Replies
2
Views
197
What is it Worth?!?!? Jun 21, 2026
riored97snake
R
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SVT Tech Forum
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?