kind of long but please help. about 4 - 6 years ago I had my 289 rebuilt with stock lower end and the person put in a hot cam and rebuilt heads, performer intake, edelbrock 600 carb, stock alt, stock fuel pump, stock distrib, etc...
it has never ran quite right and after a few hundred mile it broke some springs because the cam was too big. long story short had the heads built with 190 and 160 stainless valves, double springs, and the shop matched it to the cam (specs still unknown) ran real rich not quite right. then it started dying at idle. run good at 2K but kind of bogs below that and dies off. still only have less than 500 miles on it total
I have replace and tested out:
new carb - still had the problem old carb ran beautifully on a chevy my neighbor has
new alt - one wire, 140A
complete fuel system - new tank, electric pump, new lines, filter etc...
new distributor -
new plugs, wires....
still wont idle and dies.
this has been a 5 year saga and I am at my end. I have dumped enough money into it and my wife wont let me buy a different engine... so I am at a loss.
could a cam cause this issue, or cam intake combo? I could possible swing a new cam and install, but seems extensive to put it together and find it still has a problem... any issues with performer intakes?
any remote thoughts, no matter how far fetched I am all ears. I have had 5 different people look at it and still no one has a clue..
it has never ran quite right and after a few hundred mile it broke some springs because the cam was too big. long story short had the heads built with 190 and 160 stainless valves, double springs, and the shop matched it to the cam (specs still unknown) ran real rich not quite right. then it started dying at idle. run good at 2K but kind of bogs below that and dies off. still only have less than 500 miles on it total
I have replace and tested out:
new carb - still had the problem old carb ran beautifully on a chevy my neighbor has
new alt - one wire, 140A
complete fuel system - new tank, electric pump, new lines, filter etc...
new distributor -
new plugs, wires....
still wont idle and dies.
this has been a 5 year saga and I am at my end. I have dumped enough money into it and my wife wont let me buy a different engine... so I am at a loss.
could a cam cause this issue, or cam intake combo? I could possible swing a new cam and install, but seems extensive to put it together and find it still has a problem... any issues with performer intakes?
any remote thoughts, no matter how far fetched I am all ears. I have had 5 different people look at it and still no one has a clue..