I got the mass-back carpet from them and it did not have any pre-cut holes -- I had to cut all of them in mine. I was surprised, the quality was actually pretty good for being a resto part. Hope this helps!!
How do you like the mass back? Does it cut down on noise and heat? Do you have any interior pictures of how far the carpet goes under the dash? That would be very helpful. Thanks for the info.
-AJ
I have the mass backing.With it and some added dynomat in spots the factory chose to miss.Mine is almost as quiet as new car.
It goes up just as far as the stockers did.
Did yours also come with no holes like COILDUP said?
No holes but the carpet is pre stamped for the seatbelt and seat track holes(not cut out but the mat is "dimpled") to show you where to cut..
Ok good. I have no carpet in the car right now, im hoping this will kill a lot of the noise and the heat. Thanks again.
-AJ
Carpet will help with the noise but why not add some sound deadening stuff while the carpet is out? I used Second Skin supplies and have been pleased with the results.
Money is the main reason why i didn't want to put dynamat or skin stuff. That why i was going with the mass backing.
-AJ
So mass-back carpet from ACC is the way to go?
I was thinking of also adding some sound deadener under it, but is it needed?
I want as quiet as possible for a Mustang.
COuld care less about saving a few pounds. I just don't want a rattle-box.
About how many square feet do you think are needed to do the interior of a Mustang?
I would prob want to do under the carpet as well as into the hatch area, up the b-pillars and the roof as well.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?