Hello I am looking for suggestions on where to start with this car. It is a 68 GT convertible. I’ve done coups but never a convertible. The car needs all structural supports redone. I will list everything that needs replaced . I am building a jig and supporting everything very good. I figure I will have to support or remove supports as I go.
I plan on doing a complete floor replacement the one that comes with rear frame rails and inner rocker brace and floor supports
Thanks again
Things that need replaced:
All front frame rails
Upper and lower cowel
A pillar drivers side was hit
Outer rockers both side
Inner or (hat) rockers both side
Both front torque boxes
Floor to cowel panel both sides
Rear quarters both side
I plan on doing a complete floor replacement the one that comes with rear frame rails and inner rocker brace and floor supports
Thanks again
Things that need replaced:
All front frame rails
Upper and lower cowel
A pillar drivers side was hit
Outer rockers both side
Inner or (hat) rockers both side
Both front torque boxes
Floor to cowel panel both sides
Rear quarters both side
Attachments
Last edited:
