I installed my Edelbrock 600 on my 67 yesterday, and it actually went quite well and works great! Only problem is I have leftover parts; there's a bar that runs from the compressor to the manifold that was right in the way of the new carb. There is NO room for it as it is now, so I left it off for now. The compressor seems to be held quite sturdily by the bracket attaching it to the block.
Does anyone now how vital this bar is? Is it just over-engineering or ?
I can look into modifying it or fabricating something else that will do the same job if necessary.
Does anyone now how vital this bar is? Is it just over-engineering or ?
I can look into modifying it or fabricating something else that will do the same job if necessary.