aod pressure port

[351w fastback]

Where is the correct port for setting up the tv cable on the aod trans? Also, i am using the lokar kickdown cable and i have a holley carb so do i need a special bracket to hook it up? I drove my 67 mustang and it would not shift at all. Any other tips for hooking up the cable? thanks

 

[Robdogg67]

There are (3) pipe plugs on the pass. side of the tranny, the pressure port is the center on. Set tension to 35psi at idle.

 

[Robdogg67]

Sorry read the rest of your post, you'll need some kind of mounting bracket at the carb end of the cable. Check the lokar website or contact them and I think you may need some special adaptor for a Holley, likely the SRK-4000. Make sure your secured correctly at the tranny and the lever moves the correct way.

 

[351w fastback]

im pretty sure i have it right now. I set the pressure with o psi at idle and then when i install the gauge tool it goes to 35 psi so i think that is correct. I have heard about a special bracket for the carb but in the lokar instructions they say to put it in the lowest 1/4" hole on the carb?