• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech

Bad head gasket?

  • Thread starter Thread starter 88stang88
  • Start date Start date Jan 11, 2011

88stang88

5 Year Member
Apr 28, 2005
309
7
39
St. Louis,MO
Jan 11, 2011
#1
  • Jan 11, 2011
  • #1
Replaced the Water pump in Feb of 2010, Replaced the thermostat in September and again in Dec, Replaced the Radiator with a stock replacement in November. System works properly as far as flowing and thermostat opening and closing and radiator is not clogged nor leaking. The problem is once you have properly gotten all the air out of the system and you start driving you go about 30 miles and then it shoots a bunch of coolant out of the overflow tank. Is this caused to a bad head gasket letting in exhaust?
 

BlackVert

15 Year Member
Oct 3, 2003
5,589
9
98
Bethesda, MD
Jan 11, 2011
#2
  • Jan 11, 2011
  • #2
could be
 

Chythar

Recently finished repairing my rear
20+ Year Stangneter
Aug 26, 2004
2,373
140
113
Foothill Ranch, CA
Jan 11, 2011
#3
  • Jan 11, 2011
  • #3
30 miles is not enough time for the coolant to heat up that much, so a bad head gasket (or cracked head) is very likely. If you pop the radiator cap and let the car idle, do you see any bubbles coming up through the open radiator neck? If so, you've definitely got exhaust pushing into the coolant.
 

88stang88

5 Year Member
Apr 28, 2005
309
7
39
St. Louis,MO
Jan 12, 2011
#4
  • Jan 12, 2011
  • #4
Kind of what I thought it would be. Good thing I had plans to put heads on once this cold weather breaks. Might end up going thru the motor since I am pulling the heads. We shall see.
 
F

fordtech28

Member
May 12, 2006
312
0
17
Riverside Cali.
Jan 12, 2011
#5
  • Jan 12, 2011
  • #5
Did you change the radiator cap? And are you using a standard cap or the one with the pressure release handle
 

88stang88

5 Year Member
Apr 28, 2005
309
7
39
St. Louis,MO
Jan 12, 2011
#6
  • Jan 12, 2011
  • #6
Changed the cap and have a new pressure handle one.
 
F

fordtech28

Member
May 12, 2006
312
0
17
Riverside Cali.
Jan 12, 2011
#7
  • Jan 12, 2011
  • #7
I've had issues with the ones with the pressure release handle

to verify if its a blown head gasket do a cooling system pressure test

Also do you see the fan turn on when the coolant is overflowing I dont want to diss you but I had people tell me their cars are overheating and I have to ask if they hear the fan turning they say yeah without seeing if its actually on
 

88stang88

5 Year Member
Apr 28, 2005
309
7
39
St. Louis,MO
Jan 12, 2011
#8
  • Jan 12, 2011
  • #8
Yes the fan comes on just fine.
 

Adam95GT

New Member
Aug 14, 2006
2,564
3
0
Burlington, NJ
Jan 12, 2011
#9
  • Jan 12, 2011
  • #9
Are you 100% sure your t state is opening? But yea a cpt /leakdown is your next step. If you don't have either a standard compression test might give you some insight
 

88stang88

5 Year Member
Apr 28, 2005
309
7
39
St. Louis,MO
Jan 12, 2011
#10
  • Jan 12, 2011
  • #10
Yes the t-stat opens. Whenever you have enough coolant in the system (prior to it evacuating itself) the heater works,fan kicks on normal everything works right. Then you start driving and like I said about 30 miles later it evacuates itself via overflow tank.
 

1987LXragtop

Member
Jan 26, 2008
837
3
18
Just outside Philly PA
Jan 12, 2011
#11
  • Jan 12, 2011
  • #11
I think 30 miles is plenty to heat the system. I just did my driver side head gasket. Getting coolant into the cylinder and fouling the plug so unburned fuel dumping in. Good sign of a bad gasket is that I got pressure in the radiator in a couple minutes and the coolant was ice cold. If youre getting pressure in there quickly when cold, then I would suspect head gasket.
 

Zero Signal

Active Member
Feb 24, 2003
2,633
2
46
Tucson, AZ
Jan 12, 2011
#12
  • Jan 12, 2011
  • #12
If you have an air compressor, definitely do a leakage test first. Pick up a leakage tester form Harbor Freight (doesn't have to be a good one) and pressurize the cylinders, one at a time with a good 100psi if you can and look for bubbles in the bottle or girgling sounds in the head.

Try to get that fixed before you blow out the water pump gasket like I did and have to change THAT too
 

88stang88

5 Year Member
Apr 28, 2005
309
7
39
St. Louis,MO
Jan 12, 2011
#13
  • Jan 12, 2011
  • #13
Well as it stands it is sitting until some nice weather comes so I can just replace the heads/cam/intake and go thru the bottom end...tired of dealing with the crap this winter
 

1987LXragtop

Member
Jan 26, 2008
837
3
18
Just outside Philly PA
Jan 12, 2011
#14
  • Jan 12, 2011
  • #14
Agreed there. Even in my garage I can only get it heated up to 40 degrees inside with the kerosene heater on full blast. Its just too cold and snowy outside.
 

88stang88

5 Year Member
Apr 28, 2005
309
7
39
St. Louis,MO
Jan 13, 2011
#15
  • Jan 13, 2011
  • #15
I think we hit 49 degrees one day with a kero heater in my brother garage...he even has a new thermal garage door too...just balls cold out
 
You must log in or register to reply here.

Similar threads

Fox Help
  • 93fox85
  • Mar 22, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
5
Views
223
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Mar 23, 2026
Noobz347
B
2001 SVT Cobra Overheating Issue
  • bradencaron0
  • May 8, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
1
Views
215
1996 - 2004 SN95 Mustang -General/Talk- May 8, 2025
Noobz347
W
High Cylinder Head Temp - Not Overheating?
  • wtfwork12
  • Jun 26, 2025
  • 2005 - 2014 S-197 Mustang -General/Talk-
Replies
9
Views
2K
2005 - 2014 S-197 Mustang -General/Talk- Jul 1, 2025
wtfwork12
W
B
Where to go from here on my build…
  • B0udreaux
  • Jul 14, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
8
Views
217
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 18, 2026
AeroCoupe
Engine Re-torquing intake manifold bolts question
  • 91GTstroked
  • Feb 22, 2025
  • Fox 5.0 Mustang Tech
Replies
6
Views
1K
Fox 5.0 Mustang Tech Mar 1, 2025
Jarhead67
J
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?