I have a 93 Cobra and I'm getting ready to install a Bassani catted x-pipe and catback on it in the very near future. I'm relatively new to the world of mods, so I was hoping for some advice.
Since I'm getting the x-pipe used, I doubt it will have any instructions or hardware. Is this pretty much a bolt-in installation, or will I need some additional hardware?
Also, it looks like the only way to get the current exhaust out is to cut it. Is there a specific section or point to do the cut that makes it easier? Or is there a certain location that is better?
Since I'm getting the x-pipe used, I doubt it will have any instructions or hardware. Is this pretty much a bolt-in installation, or will I need some additional hardware?
Also, it looks like the only way to get the current exhaust out is to cut it. Is there a specific section or point to do the cut that makes it easier? Or is there a certain location that is better?