Today since it was raining decided to try to mate the 3 spd standard trans I recieved with my 1966 mustang and a bellhousing that was also inside the car. When recieved they were not mated but I just assumed they went with each other.
anyways so I lined the top mounting holes of bell housing to top moutning holes of trans and tried to center it and the holes all line up but with no avail the front bearing retainer is to large to fit inside the bell housing hole.
Im trying to find out what the bellhousing actually goes to and the only code I was able to find is the ford part code
C3AA - 6394 - C
So if im reading this correctly and correct me if im wrong
C3 = Year 63
A = Ford Full Size
A = Chassis
6394 = part #
C = Third version of this part
The Trans is:
HEF - CW
1966 289cid, 3.03, After 11/1/65
which would match my year car
any help would be greatly appreciated
Dave
anyways so I lined the top mounting holes of bell housing to top moutning holes of trans and tried to center it and the holes all line up but with no avail the front bearing retainer is to large to fit inside the bell housing hole.
Im trying to find out what the bellhousing actually goes to and the only code I was able to find is the ford part code
C3AA - 6394 - C
So if im reading this correctly and correct me if im wrong
C3 = Year 63
A = Ford Full Size
A = Chassis
6394 = part #
C = Third version of this part
The Trans is:
HEF - CW
1966 289cid, 3.03, After 11/1/65
which would match my year car
any help would be greatly appreciated
Dave