• Mustang Forums
  • 2005 - 2014 S-197 Mustang -General/Talk-
  • 2005 - 2009 Specific Tech

Bent axle

  • Thread starter Thread starter Fast05
  • Start date Start date Aug 3, 2006

Fast05

New Member
Sep 16, 2005
409
1
0
Corpus Christi, TX
Aug 3, 2006
#1
  • Aug 3, 2006
  • #1
Ok well first the good news: The bumper and fender are fixed from my accident and the wheel has been replaced with a brand new oem one.

Now the bad news: They called me this morning to tell me my car would be ready for pick up this afternoon. So I go, look everything over, and am thrilled I'm getting my car back after almost 3 weeks of being in the shop. So I'm driving to the rental car place with the rental car agent driving the rent car behind me. I go over 25mph and hear this god awful squeal/squeaking coming from the wheel that was hit in the accident. I called the person behind me (i'm a personal friend of hers) and she tells me the wheel is wobbling like crazy. Well I wanted to see this for myself but she can't drive stick so I called the shop and was like WTH?? The guy handling my claim told me to drive it back asap, they took a look at it and determined that the axle needs to be replaced. I asked why they didn't find this earlier, and he tells me they were in such a rush to get my car back to me that they didn't have time to take it for a drive!!

So my question is, how long do you think it would take a professional with all the right tools to replace an axle assuming they have one in stock? And when I installed my gears I used a different gear oil other than stock, do I need to let them know? And I'm assuming they're going to have to tear the rear end apart and put it back together? If so I'm going to be pissed if they screw it up, I have to drive the thing out of state in a few weeks and I better not hear any gear whine.

Sorry, just had to vent
 

bigcat

start with the upper hole, and if more traction is
May 1, 2005
3,015
1
79
7200 feet
Aug 3, 2006
#2
  • Aug 3, 2006
  • #2
most likely they will put a USED assembly in there. better check into it now, before its too late. if they do install an entire assembly (new or used), it should be done in a few hours. not too bad of a project. now if they get a new rear and then have to install new gears as well, then it may be a couple days total.
 

Unbrdld07

Member
May 4, 2005
0
0
18
Where eagles dare
Aug 3, 2006
#3
  • Aug 3, 2006
  • #3
I am sooooo sorry. At this point make sure you GET a factory part, not some cheap a$$ piece of crap, after all it's your car not the insurance companies. Sure they have to pay for it, BUT so do YOU in the END even if it's not your fault.
 

fin1

New Member
Mar 30, 2005
56
0
0
Aug 4, 2006
#4
  • Aug 4, 2006
  • #4
It depends on the damage. If the axle is bent and the axle housing is OK it's not much to replace the OEM axle. I would not worry about the oil Ford uses, it will be fine but they will need to drain it and remove your rear-end to put the new axle in. If the housing is bent, then the entire rear axle housing will need replaced. Still not a big deal for a good dealer just more parts to order. I highly doubt they have axles in stock so just be patient while they order the parts. Have them do an alignment check too when done.

Have them check your rotor, pads and caliper to make sure you didn't damage them when you drove it.
 
You must log in or register to reply here.

Similar threads

S
Hi. I'm new. 98 Cobra Bent Axle.
  • sbk93036
  • Mar 28, 2026
  • The Welcome Wagon
Replies
1
Views
66
The Welcome Wagon Mar 28, 2026
AeroCoupe
S
Car shakes when taking off help???
  • STANKYstangs
  • May 10, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
12
Views
186
1996 - 2004 SN95 Mustang -General/Talk- May 27, 2026
LILCBRA
There’s nothing sexier than a woman driving a Mustang!
  • MKatzenbach
  • Mar 20, 2026
  • 2015 - 2023 (S550) Mustang -General/Talk
  • 2
Replies
21
Views
562
2015 - 2023 (S550) Mustang -General/Talk May 2, 2026
Noobz347
Hello Mustang community!
  • MKatzenbach
  • Mar 13, 2026
  • The Welcome Wagon
Replies
6
Views
196
The Welcome Wagon Mar 14, 2026
MKatzenbach
Vacuum line question?
  • Mustang Momma
  • Feb 10, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
1
Views
137
1996 - 2004 SN95 Mustang -General/Talk- Mar 3, 2026
Noobz347
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 2005 - 2014 S-197 Mustang -General/Talk-
  • 2005 - 2009 Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?