• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

Best plugs for hard street racing & DD

  • Thread starter Thread starter whyask
  • Start date Start date Oct 30, 2006
  • 1
  • 2
Next
1 of 2 Next Last

whyask

New Member
Apr 4, 2005
735
1
0
Sacramento
Oct 30, 2006
#1
  • Oct 30, 2006
  • #1
getting tuneup this week and changing plugs, I love to get on it and im a daily driver, what plugs to go with?
 
9

97stang4.6L

New Member
Oct 31, 2006
16
0
0
Oct 31, 2006
#2
  • Oct 31, 2006
  • #2
Everyone has there own preference of plugs. a few brands i prefer are NGK, Motorcraft, and Autolite. Spark plugs are not really a performance item unless you are running nitrous or some other kind of boost. they are mainly a maintenece item. the only way you are probably going to feel a power increase is if the old plugs are shot. i have autolite in my GT and they work fine.
 
P

Pennywise2

Banned
May 16, 2006
1,379
1
0
Oct 31, 2006
#3
  • Oct 31, 2006
  • #3
If your mustang is N/A than Motorcraft or Autolite
spark plugs would be the best choices.
 
E

exindust

New Member
May 8, 2004
329
0
0
Moorpark, CA
Oct 31, 2006
#4
  • Oct 31, 2006
  • #4
Motocraft

Because Kilgore Said So
 

stangGT97

New Member
Dec 22, 2004
1,299
1
0
Boston area, MA
Oct 31, 2006
#5
  • Oct 31, 2006
  • #5
Autolite 764 or Motorcraft AGSF-32Cs gapped @ 0.054. If you're running into detonation issues, drop a heat range to AGSF-22Cs or Autolite 103s.
 

whyask

New Member
Apr 4, 2005
735
1
0
Sacramento
Oct 31, 2006
#6
  • Oct 31, 2006
  • #6
sweet thanks guys thats all I needed
 

Matt's 03 GT

Member
Aug 28, 2006
0
0
17
Orange County
Oct 31, 2006
#7
  • Oct 31, 2006
  • #7
stangGT97 said:
Autolite 764 or Motorcraft AGSF-32Cs gapped @ 0.054. If you're running into detonation issues, drop a heat range to AGSF-22Cs or Autolite 103s.
Click to expand...

Is there any issue with running the lower heat range on a mostly stock engine?
 

stangGT97

New Member
Dec 22, 2004
1,299
1
0
Boston area, MA
Oct 31, 2006
#8
  • Oct 31, 2006
  • #8
Matt's 03 GT said:
Is there any issue with running the lower heat range on a mostly stock engine?
Click to expand...

It really depends on how hard you drive your car really. I'm easy on mine and don't rev the crap out of it on a daily basis, so the stock heat range works for me. In fact, I ran the 22Cs for a week and my car felt sluggish, running the normal heat range cured the problem. So I guess my recommendation would be:

You drive the crap out of your car - 1 heat range colder
You drive normally, occasionally run it through the gears - stock heat range.

This is what works on my car though, it may be different for you so keep that in mind. Randy Stinchcomb recommends a heat range colder for stock engines, and 2 heat ranges colder for modified... for some reason my car did not like it at all though, not sure why
 

Team Ford

Member
Dec 16, 2005
109
3
19
Oct 31, 2006
#9
  • Oct 31, 2006
  • #9
can you elaborate on heat range a little more.
 

stangGT97

New Member
Dec 22, 2004
1,299
1
0
Boston area, MA
Oct 31, 2006
#10
  • Oct 31, 2006
  • #10
Team Ford said:
can you elaborate on heat range a little more.
Click to expand...
Ok, heat range has to do with the heat transfer properties of a spark plug... and it has nothing to do with the spark itself. A spark plug that is 1 heat range colder will remove more heat from the tip of the plug, lowering combustion temperatures - this will aide greatly in helping to prevent preignition/detonation. If your combustion temperatures are too high, your fuel can pre-ignite, before being fully compressed and ignited with the spark. This will lead to audible pinging and eventually the destruction of your engine (if not corrected quickly). So if you are having detonation problems, sometimes a higher octane fuel can correct it, but if not, running 1 step colder might do the trick.

That being said, if you don't experience any pinging with your stock heat range plugs, even if you drive the hell out of your car, then dropping down a heat range may or may not benefit you at all. If you're running too cold of a plug, the tip will not get hot enough to burn off deposits and they will foul easily. In a FI application, where you get a very dense air charge being stuffed into the combustion chamber, it is required to drop either 1 or 2 heat ranges and to narrow the electrode gap.

Do a google search, there is a lot of info out there about this stuff
 

streetstang03

unModerator
Dec 27, 2003
0
1
0
the dark side of the moon/home of the 1999, 2003,
Oct 31, 2006
#11
  • Oct 31, 2006
  • #11
street racing?

say hi to Vin for me when you see him on the streets
 

myponyrocks

I have more billet on the Stang than most women ha
Apr 18, 2004
1,219
0
37
Oct 31, 2006
#12
  • Oct 31, 2006
  • #12
you meant for "Hard street driving, Racing, and normal DDing" right?
 

Matt's 03 GT

Member
Aug 28, 2006
0
0
17
Orange County
Oct 31, 2006
#13
  • Oct 31, 2006
  • #13
Thanks very much. I have been having a Pinging problem when the temp is over about 80 degrees. I may try the colder plugs to see how it changes... I'll let you know.

:SNSign:
 

stangGT97

New Member
Dec 22, 2004
1,299
1
0
Boston area, MA
Oct 31, 2006
#14
  • Oct 31, 2006
  • #14
Matt's 03 GT said:
Thanks very much. I have been having a Pinging problem when the temp is over about 80 degrees. I may try the colder plugs to see how it changes... I'll let you know.

:SNSign:
Click to expand...

OK man, I hope that information is helpful to you. Being that you have an '03, I wouldn't think that carbon buildup could be an issue. I do believe that the PI motors are more prone to pinging for some reason (not sure) so a set of AGSF-22Cs gapped @ 0.054 may take care of your problem. Beware that copper plugs have a higher gap erosion rate than platinum, so you will need to pull them every so often to check the gap. I was also advised by Randy to gap @ 0.048, then by the time you're ready to change the plugs the gap will have moved out to about 0.054". It all depends on how comfortable you are with pulling the plugs from your heads though. Good luck you man! Oh and Homer Simpson is da bomb
 

Matt's 03 GT

Member
Aug 28, 2006
0
0
17
Orange County
Oct 31, 2006
#15
  • Oct 31, 2006
  • #15
........Carbon buildup, mmmmmmmmmmmmmmmmmmm................
<best homer voice>

Yeah, I think I will try this and let you know. The car only has 33,000 miles on it. I also live in the land of **it gasoline in so cal. We had to run this car on 92 octane through the summer and it only has CAI and a cat back exhaust.

We'll see if next summer is any better.

Homer rocks!! :SNSign:
 

stangGT97

New Member
Dec 22, 2004
1,299
1
0
Boston area, MA
Oct 31, 2006
#16
  • Oct 31, 2006
  • #16
another thing to check is the MAF. If you're running an oiled filter, it could be contaminated, and that could cause pinging.
 
Y

Yellow2002GT

New Member
Feb 20, 2006
148
1
0
Raeford, NC/ FT Bragg
Oct 31, 2006
#17
  • Oct 31, 2006
  • #17
Too many bolts ons and no custom tune will cause pinging! Our cars love a good tune! Fuels and timing corrected with allow for more power and less pinging. As far as plugs go.....go with the AP764's........They burn hot and with a good tune...idle really nice!

"ED"
 
P

Pennywise2

Banned
May 16, 2006
1,379
1
0
Oct 31, 2006
#18
  • Oct 31, 2006
  • #18
exindust said:
Motocraft

Because Kilgore Said So
Click to expand...
The good thing about installing Motorcraft spark plugs
is that they come pre-gapped.
 

stangGT97

New Member
Dec 22, 2004
1,299
1
0
Boston area, MA
Oct 31, 2006
#19
  • Oct 31, 2006
  • #19
Pennywise2 said:
The good thing about installing Motorcraft spark plugs
is that they come pre-gapped.
Click to expand...

only the platinums come pre-gapped, gotta gap the coppers yourself
 

Dan_Soprano

15 Year Member
May 7, 2003
7,410
54
129
Jacksonville, FL
Oct 31, 2006
#20
  • Oct 31, 2006
  • #20
NGK TR-6
 
  • 1
  • 2
Next
1 of 2 Next Last
You must log in or register to reply here.

Similar threads

M
Help! 2003 GT misfire when hot
  • Modular03
  • Feb 10, 2026
  • SN95 4.6L Mustang Tech
Replies
4
Views
402
SN95 4.6L Mustang Tech Feb 13, 2026
Mustang5L5
K
Engine 2000 Mustang GT - Fuel issue post-blown spark plug repair
  • kenster1092
  • Feb 26, 2026
  • SN95 4.6L Mustang Tech
Replies
4
Views
372
SN95 4.6L Mustang Tech Mar 10, 2026
kenster1092
K
96 GT 4.6 w/ dirty spark plug well
  • Mustang Momma
  • Apr 7, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
3
Views
132
1996 - 2004 SN95 Mustang -General/Talk- Apr 9, 2026
LILCBRA
Who the hell puts the wrong spark plugs in a 3.8L?
  • snowstang
  • Mar 25, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
12
Views
445
1996 - 2004 SN95 Mustang -General/Talk- Apr 3, 2026
LILCBRA
S
Holley High-ram tuning settings
  • spencergt66
  • Apr 1, 2026
  • Digital Self-tuning Forum
  • 2
Replies
28
Views
661
Digital Self-tuning Forum Jun 19, 2026
spencergt66
S
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?