Damn amount of cam choices out there are dizziing. Here is what I have come up with so far.
-Stock shortblock and pistons
-Edelbrock performer RPM heads (stud mount) with 1.90 valves
-Springs are supposedly good to .575 lift with 120 (seat/installed), 320 (open/installed)
-I do not want to have to fly cut pistons at all to make room for a camshaft.
Here are the choices I am looking at so far.
TFS stage 1....221 intake/225 exhaust .312 in./.319 in. .499 in./.510 in. 112 (139)
TFS stage 2...224 intake/232 exhaust .339 in./.352 in. .542 in./.563 in. 112 (149)
Comp Cams 35-312-8...220/224 .544/.560 114lsa (239)
Crane Cams 444221...216/220 .533/.544 112lsa (179)
Crane Cams 449651...226/232 .544/.559 ?lsa (320)
Are all of these cams cut from billet steel if they are for roller applications and does that facilitate the necessity of a bronze timing gear or is that only for mechanical cams....?
Lastly, at what point in duration does the stock computer start going haywire....?
Also, what length pushrod is the stock pushrod on Mustangs. I will need to run a hardenend pushrod for my application and supposedly all of these cams have stock basecircles. What pushrods are you guys out there running with heavy springs and guideplates...?
-Stock shortblock and pistons
-Edelbrock performer RPM heads (stud mount) with 1.90 valves
-Springs are supposedly good to .575 lift with 120 (seat/installed), 320 (open/installed)
-I do not want to have to fly cut pistons at all to make room for a camshaft.
Here are the choices I am looking at so far.
TFS stage 1....221 intake/225 exhaust .312 in./.319 in. .499 in./.510 in. 112 (139)
TFS stage 2...224 intake/232 exhaust .339 in./.352 in. .542 in./.563 in. 112 (149)
Comp Cams 35-312-8...220/224 .544/.560 114lsa (239)
Crane Cams 444221...216/220 .533/.544 112lsa (179)
Crane Cams 449651...226/232 .544/.559 ?lsa (320)
Are all of these cams cut from billet steel if they are for roller applications and does that facilitate the necessity of a bronze timing gear or is that only for mechanical cams....?
Lastly, at what point in duration does the stock computer start going haywire....?
Also, what length pushrod is the stock pushrod on Mustangs. I will need to run a hardenend pushrod for my application and supposedly all of these cams have stock basecircles. What pushrods are you guys out there running with heavy springs and guideplates...?