• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2.3L (N/A & Turbo) Tech

car problems...need a bit o help?

  • Thread starter Thread starter 89projectstang
  • Start date Start date Jan 10, 2006
8

89projectstang

New Member
Dec 14, 2005
64
0
0
Jan 10, 2006
#1
  • Jan 10, 2006
  • #1
i have a small issue and i was wondering if anyone could help me out.

i have an 1989 2.3l AOD n/a. my car starts and idles perfectly fine but earlier today whenever i put my car into gear (any of them other than P and N) the car instantly stalls out.

i, not knowing anything about cars, figured my tranny finally gave out on me so i bought all the parts to do a T-5 swap. but my question is...would a bad AOD really make my car stall out like that? if its not the tranny what could it be?

thanks!
 
J

jgt58

New Member
Jan 17, 2003
92
0
0
Knoxville,TN
Jan 10, 2006
#2
  • Jan 10, 2006
  • #2
just a guess , but maybe your not getting any vaccum in the auto trans....
 
L

lit_mike_2001

New Member
Jan 25, 2003
163
1
0
Ada, OK
Jan 11, 2006
#3
  • Jan 11, 2006
  • #3
whats it do when you rev up the motor and put it in drive
 

rd

Founding Member
Jan 12, 2000
3,316
63
109
Ocean Springs MS
Jan 11, 2006
#4
  • Jan 11, 2006
  • #4
Your 2.3 l NA car should have an A4LD, four speed overdrive automatic. If the tranny worked until just now, I would look at engine probs first. Pull the codes before you do anything.

Some GMs have this problem if the torque converter lockup solenoid sticks in the engage postion, but the a4ld uses the solenoid to inhibit tcc lockup; it is acutated via plain old hydraulics and vacuum controls, in an 89. So at idle, there should not be any easy way to lock it.

I have had stalling with mine for various reasons, like the fan not coming on, and the ac compressor building up enough pressure to stall the motor.

Read the codes via the cel, or a scanner, before you do much else. It will cost less in the long run.
 
8

89projectstang

New Member
Dec 14, 2005
64
0
0
Jan 11, 2006
#5
  • Jan 11, 2006
  • #5
ok...

ok heres what it does.

i can start the car and it will run fine. not a problem. but when i put it into drive, overdrive, 1, 2, or reverse (anything over than park or neutral) it instantly stalls out on me.

i was planning on swapping out the transmission from a AOD to a t-5 anyways this month. i just want to make sure when i get the swap finished my car still wont do the same thing, stall out when i put it in gear.

also ive been having some issues with my AOD anyways, a few days ago my car woudlnt shift out of first gear while i was driving...really really annoying. normally it had problems shifting only when the car was started in the morning, but as of late its been happening more frequently until the said problem happened.
 

rd

Founding Member
Jan 12, 2000
3,316
63
109
Ocean Springs MS
Jan 12, 2006
#6
  • Jan 12, 2006
  • #6
Sounds like you may have the torque converter dying, or the clutch is locked up.

With the engine off, and the car in n, drive, etc, will it roll, or can you push it without turning the engine?
 
8

89projectstang

New Member
Dec 14, 2005
64
0
0
Jan 13, 2006
#7
  • Jan 13, 2006
  • #7
with the car off and the car in D the car does roll back and i can push it. i havent tried any other gears. but i have noticed that one. will switching to a t-5 correct this problem?

thanks for everything!!
 
You must log in or register to reply here.

Similar threads

S
idles perfect then jolts and cuts out when put into Reverse or Drive.
  • shanesstangs
  • Mar 12, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
4
Views
181
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Apr 27, 2026
General karthief
S
Fox '87 GT can't get to stay running
  • spilly
  • Mar 29, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
26
Views
567
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Apr 25, 2026
CAMTWO1070
Tunerstudio help / services
  • Kabuki_notch
  • Apr 26, 2026
  • Digital Self-tuning Forum
Replies
2
Views
233
Digital Self-tuning Forum May 2, 2026
Mustang5L5
S
Engine Stalls when downshifting/coasting
  • Scott_S
  • Nov 5, 2025
  • Fox 5.0 Mustang Tech
Replies
11
Views
643
Fox 5.0 Mustang Tech Nov 6, 2025
Mustang5L5
J
Emission problems
  • jls.zmmr
  • Feb 5, 2026
  • 1994 - 1995 Specific Tech
Replies
2
Views
208
1994 - 1995 Specific Tech Feb 7, 2026
AeroCoupe
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2.3L (N/A & Turbo) Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?