• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

car pulls to the left when I hit the gas- mainly on highway

  • Thread starter Thread starter 68 & 00 GT
  • Start date Start date Dec 16, 2003
6

68 & 00 GT

New Member
May 14, 2003
2,407
1
0
HOUSTON TEXAS
Dec 16, 2003
#1
  • Dec 16, 2003
  • #1
I'm stumped on this one. Some one please help me. Some may have noticed several of my recent post about alingment, shocks, and struts, and / or springs.

Anyway here's the deal. When i'm on the highway it's most noticeable. At first I thought it was all the recent wind, then wasn't sure if the front end was just raising up when I hit the gas, but it's definately pulling my car to the left when I step on it. Mainly when I'm in fourth and roll into the gas at 60-70mph. I just got my car alinged yesterday and it's "with in factory specs now" . It did help some, but, the alingment guy said he could be more exact if I had CC plates. I have an Eibach pro kit, on factory springs. I'm at 94K miles. So what's the deal here ? My car still wanders on the road a little too. I put in MM rear LCA's a long time ago. They say my shocks and struts need replacing just b/c of my mileage. Could that make it pull like that ?
Any suggestions ? My car rides like garbage -
 

nyuk98gt

15 Year Member
Oct 10, 2000
1,427
6
79
Chesterfield, MO
Dec 16, 2003
#2
  • Dec 16, 2003
  • #2
68 & 00 GT:

Check the upper and lower control arms (rear) as you may be getting some slop leading to "rear steering". In particular, look at the rubber bushings on the UCAs. They may be tired if you have been launching hard. Also, the MM Tech Line can also provide good info -- you have their LCAs so they should treat you right.

Check your tire pressure, too.

Last thing I can think of is to rotate your tires to see if one of the tires is causing the unwanted steering.

Hope this helps.
 

JonJon

Founding Member
Aug 16, 2002
4,801
1
68
back in Marylands
Dec 16, 2003
#3
  • Dec 16, 2003
  • #3
Check tire pressure. I don't know anything about suspension though :\
 

downsouthman1

Member
Dec 16, 2003
643
0
16
Texas
Dec 16, 2003
#4
  • Dec 16, 2003
  • #4
Yes. Tire pressure needs to be even from left to right or vise versa. Also camber plates do help tremendously but if your drop is 2" or less I can't see why they'd be necessary.
 

'96&'01Stang

New Member
Feb 10, 2003
798
0
0
Georgia
Dec 16, 2003
#5
  • Dec 16, 2003
  • #5
check your wheel bearings too
 
6

68 & 00 GT

New Member
May 14, 2003
2,407
1
0
HOUSTON TEXAS
Dec 16, 2003
#6
  • Dec 16, 2003
  • #6
hmmm.

good info - just thought about this. I have two different type tires on the rear. Both 275 / 40 17 Goodyears, but different types. One is like the stock GT Goodyear, and the other more like a Cobra Stock Goodyear. Maybe that's it.
Here's pics of the tires (the bottom two) - But that not my only problem. My car still feels like crap, and my steering wheel sits crooked now after the alingment - how do Ifix that. Pull the steering shaft (as I did on my LT install), and adjust it there, or can it only be put back together one way in that fitting ?


My Pro Kit is only supposed to be a 1.5 drop. Would CC plates help ?
At my mileage w/ stock shocks, and struts used on the Pro Kit worn out like they say?

I'm (unfortunately) suspending myself from any other mods until I fix this -
 

nyuk98gt

15 Year Member
Oct 10, 2000
1,427
6
79
Chesterfield, MO
Dec 17, 2003
#7
  • Dec 17, 2003
  • #7
68 & 00 GT:

The alignment shop can straighten out the steering wheel (tie rod adjustments). I would not mess with the steering shaft linkage (just because it is not the "official" method of straightening out the steering wheel).

As for the different tires, are the two front tires worn down the same? I am thinking that the circumference is different between the two (one is slightly taller than the other). This could be a contributing factor. If you can borrow a friend's two front wheels/tires for a test drive, this will confirm whether the tires are the problem.

Original shocks and struts usually only last 30 to 60,000 miles, depending on local road conditions. The soft joint holding the struts in place could be worn out, too, but the alignment shop should have commented about it.

I put in CC plates with only a 1.4 to 1.6" drop -- relatively cheap insurance against premature wear and, more importantly, the adjustability to make the car handle better.

Keep us up to date on what you find, please.

Chris
 
6

68 & 00 GT

New Member
May 14, 2003
2,407
1
0
HOUSTON TEXAS
Dec 17, 2003
#8
  • Dec 17, 2003
  • #8
All four of those tires are to be used on the rear. I have Kuhmo Estcas on the front w/ about 60% tread left. Only the bottom two are on the rear. That why I wondered if having two different tires on the rear was causing my problems even though they are the same size, and make. I'm almost to the point to just save some $$, and throw it in on sub frames, shocks, and struts, tower support brace, upgraded sway bars etc..... - My ride quility is not good. I'm frustrated, but unfortunately don't have a bunch of cash to just start buying parts -
 

Scrody96GT

Founding Member
Oct 3, 2001
342
0
0
Greenhill, AL (Florence)
Dec 17, 2003
#9
  • Dec 17, 2003
  • #9
I'm sure many of you know about this, but if not here's a great site giving a thorough explanation of most components of the Mustang suspension.

http://www.miracerros.com/mustang/t_suspension.htm
 
You must log in or register to reply here.

Similar threads

S
Car shakes when taking off help???
  • STANKYstangs
  • May 10, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
12
Views
338
1996 - 2004 SN95 Mustang -General/Talk- May 27, 2026
LILCBRA
B
For Sale 1986 Mercury Capri 5.0 5-speed
  • blackmerc
  • Jul 29, 2026
  • Fox Body Mustangs For Sale (1979-93)
Replies
7
Views
136
Fox Body Mustangs For Sale (1979-93) Yesterday at 9:15 PM
blackmerc
B
N
Fox Street Suspension Build Advice
  • NYFox
  • Jan 25, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
322
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jan 28, 2026
Noobz347
A
2001 Mustang GT, scorched metal smell and noise from trans/diff?
  • AndyE2255
  • Dec 1, 2025
  • SN95 4.6L Mustang Tech
Replies
4
Views
469
SN95 4.6L Mustang Tech Dec 28, 2025
gkomo
Buying with a bad motor?
  • djj62478
  • Mar 8, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
8
Views
303
1996 - 2004 SN95 Mustang -General/Talk- Mar 11, 2026
TTSaleen
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?