Ok so the problem with my car is that it wont start when hot. I messed around with some things then decided to pull the codes to see if there was anything wrong. Ive never had to do this before so I searched and found jrichkers post explaining how to do it. I made a jumper wire and plugged it into the single wire test connector then into the number 2 plug on the diagnostivcs port. Next I took a testlight and clipped it to the positive battery post and hooked it to the number 3 pin on the diagnostics port. I turned the key to on and nothing happened. I chekced all plugins to be sure they were connected and tried again. Not a single flash. SO I start the car to see if the koer codes will display and theres nothing there also. I am sure there is good connections at all ports. Was I hooking everything up right?