Codes

rotorhead22

Active Member
Dec 17, 2020
175
89
38
Wesley Chapel, Florida
I have a 89 LX which has a very rich exhaust smell. I installed a after market gauge cluster so the maintenance light is disconnected. I have read some articles about clearing codes and using a light to read codes from a connector by the fire wall however I’m not sure which two pins to jump for this process
 
 
  • Like
Reactions: rotorhead22
Code reader with key on had 11, 10 car running just produced a "cylinder 8" so looking at my plug wires, #6 boot was on the plug end but not all the way on which smoothed out my idle. Now i dont have the cam I thought I had. Theoretically how long should I drive the beast in order to get any readings after completely dumping the stored codes? I dumped all of the old codes due to the fact I purchased the car over a year ago and it wasn't running when I got it (dead TPI) so time to start fresh.
 
Rotor head, do you have a Harley? You look like one of my bro's from the past....
DSCF0871.webp