stephen4785 New Member Dec 14, 2003 321 0 0 Fort Worth Texas Oct 30, 2004 #1 Oct 30, 2004 #1 In the middle of replacing my bell housing and I cant find the torque rating for the bolts.
65fastback2+2 New Member Aug 4, 2003 1,229 0 0 Louisville, KY Oct 30, 2004 #2 Oct 30, 2004 #2 i dont think there is a spec, i think it is just tighten em down as much as you can
J JB66 New Member Aug 21, 2004 565 1 0 New York Oct 30, 2004 #3 Oct 30, 2004 #3 My 70 book says 40-50 ft-lbs bell to eng. 28-40 bell to trans case
J JB66 New Member Aug 21, 2004 565 1 0 New York Oct 30, 2004 #4 Oct 30, 2004 #4 Same specs in 66 book
stephen4785 New Member Dec 14, 2003 321 0 0 Fort Worth Texas Oct 30, 2004 #5 Oct 30, 2004 #5 Alright . Thanks. I was talking about the bell housing to pump bolts.
stephen4785 New Member Dec 14, 2003 321 0 0 Fort Worth Texas Oct 30, 2004 #6 Oct 30, 2004 #6 i shouldve been more specific
J JB66 New Member Aug 21, 2004 565 1 0 New York Oct 31, 2004 #7 Oct 31, 2004 #7 No problem. Support Assy. to Front Pump 12-20 ft-lbs