Driver Door Handle about to break!!

Just roll down your window and get in NASCAR style. Or get in the passenger side and climb over the center console.

huesmann said:

Just roll down your window and get in NASCAR style. Or get in the passenger side and climb over the center console.

Click to expand...

The dealer is full of *****

I had this same problem on my 99 SVT. The handle is NOT held on with rivets, its held on with two brass nuts with floating washers. All you have to do to fix this problem is open up the door, roll the window up, and thread the nuts back on. I highly doubt you'll need to even buy new hardware, b/c if the nut has fallen off, it'll be rolling around in the door somewhere. Just put some blue loctite on it and you wont have to mess with it ever again.

I did my drivers side door start to finish in about an hour, but that was with alot of time figuing out how to get the door panel back in correctly. THe passenger side door I fixed literally in less than 15 minutes.

Get a Haynes manual if you dont allready.

All this fix is, is literally loctiting two nuts per door handle. Its very easy, just go slowly with the plastic panels until you see how they come apart.