M MustangMark Founding Member Jul 4, 1999 345 0 17 Mandan, ND May 31, 2006 #1 May 31, 2006 #1 does anyone know the spec for rod bearing side clearance (clearance between two rods on same crankpin)?
does anyone know the spec for rod bearing side clearance (clearance between two rods on same crankpin)?
jadesville the polarbear conservation corps protects a polarb 20+ Year Stangneter Oct 8, 2003 2,189 0 47 Gresham, OR May 31, 2006 #2 May 31, 2006 #2 http://www.hardcore50.com/technical_articles/cleances&torque_specs.htm SoCalCruising Founding Member Jul 25, 2000 2,437 0 47 SoCal May 31, 2006 #3 May 31, 2006 #3 Mine were .013-.014" on all journals. I believe that .010" is minimum and not-to-exceed is .020". M MustangMark Founding Member Jul 4, 1999 345 0 17 Mandan, ND May 31, 2006 #4 May 31, 2006 #4 well, i just got done checking it, and found all good, but one set to be under spec. not yet sure how do deal with it. thinking i should just load up the short block and take to the machine shop and then then can shave down one of the rods a bit.
SoCalCruising Founding Member Jul 25, 2000 2,437 0 47 SoCal May 31, 2006 #3 May 31, 2006 #3 Mine were .013-.014" on all journals. I believe that .010" is minimum and not-to-exceed is .020".
M MustangMark Founding Member Jul 4, 1999 345 0 17 Mandan, ND May 31, 2006 #4 May 31, 2006 #4 well, i just got done checking it, and found all good, but one set to be under spec. not yet sure how do deal with it. thinking i should just load up the short block and take to the machine shop and then then can shave down one of the rods a bit.
well, i just got done checking it, and found all good, but one set to be under spec. not yet sure how do deal with it. thinking i should just load up the short block and take to the machine shop and then then can shave down one of the rods a bit.