After the installtion of my KB SC I'm now getting the follwoing error code P0122. Has anyone seen and been able to fix the problem. KB says its a sensor that has gone bad?
P0122 Code: Throttle/Pedal position sensor A circuit low in put.
^^ The TPS will always fluctuate in a 0 - 5v range. It recieves a 5v signal from the PCM, and based on throttle input, sends a signal within a 0 - 5v range back to the PCM.
First, I'd look up the thread about setting the TPS, it may just be off if you removed it from the TB at all. If thats not an issue, you need to get your hands on a wiring diagram and service manual to check the TPS and make sure its operating as it should.