yeah lol all you have to do is put a paper clip in the gray connector just push it in to touch both terminals...oh and remember to remove it when done lol
Short the two pins in the grey connector momentary and the door locks will cycle, once they cycle remove the short and then follow the rest of the instructions.
Short the two pins in the grey connector momentary and the door locks will cycle, once they cycle remove the short and then follow the rest of the instructions.
in the pic below is this the gray connector circled in white???? and also in the pic the connector circled in red is the connection for the keyless module and the wire circled in yellow is a radio antenna wire that plugs into the side of the module all of these are installed in my mustang from the factory without the keyless entry option on my stang......thanks for the picture driggins...
wait so what if you have the alarm and the keyless entry, I pulled the alarm cartridge out because it was acting up, and then the keyless did not work. Is the keyless entry hooked up to the alarm system as well?
wait so what if you have the alarm and the keyless entry, I pulled the alarm cartridge out because it was acting up, and then the keyless did not work. Is the keyless entry hooked up to the alarm system as well?
I had the same problem, and when I took mine out it had all the wires labeled, and I seem to remember some of the wires were for the keyless entry. Was yours in the trunk or under the dash?