I have a 66 and I have come to the conclusion that I am going to have to cut the cowl section out and make a new one.
The 4 bolts for the pedal assembly sit roughly 3/4 of an inch below the pinch weld and for whatever reason, Ford gave the wiper motor a TON of room.
I got rid of the wiper motor/arms/blades awhile back, its a fake race car and doesn't get driven in the rain, but I wanted to see if anyone had done anything else.
I could do a hydraulic setup . . . who makes an affordable kit though?
Z-bar is out of the question.
I think I might just end up cutting it because for one: I can look back and know that I did it and two: its much cheaper to cut and weld.
I'll be sure to bring a camera . . .
So, has anyone done this? How did it turn out? Regrets?
thanks in advance!
The 4 bolts for the pedal assembly sit roughly 3/4 of an inch below the pinch weld and for whatever reason, Ford gave the wiper motor a TON of room.
I got rid of the wiper motor/arms/blades awhile back, its a fake race car and doesn't get driven in the rain, but I wanted to see if anyone had done anything else.
I could do a hydraulic setup . . . who makes an affordable kit though?
Z-bar is out of the question.
I think I might just end up cutting it because for one: I can look back and know that I did it and two: its much cheaper to cut and weld.
I'll be sure to bring a camera . . .
So, has anyone done this? How did it turn out? Regrets?
thanks in advance!