I have a set of ProComp 210cc heads. They had about 5000 miles over a couple of summers. They are back from the shop with a fresh valve job, decked .002" just to clean the surface and make sure they were flat. They have hydraulic roller springs good to .600 lift, 7/16 studs and guide plates. The bowls were cleaned up and the chambers had the ridge around the intake valve removed and smoothed. They are clean and ready to bolt on. $640 shipped.
aktyler@juno.com
517-750-9363
Ken
aktyler@juno.com
517-750-9363
Ken