Ok, so I bought an Aluminum Drive shaft off an AWD Aerostar. Its a '96. I read this post: http://www.stangnet.com/mustang-forums/743202-awd-aerostar-aluminum-driveshaft.html
So what I want to know is what isn't mentioned in this post.
1. Will the rear flange bolt right up to the rear-end? Or should I reuse the one on the old D/S?
2. What U-Joints should I use? Aerostar U-Joints or Mustang U-Joints?
3. The yoke (that goes in to the tranny) has 27 splines, Do I need to use the old one or is this one fine?
Thanks.
Once again Aluminum Drive Shaft off a 1996 AWD Aerostar.
So what I want to know is what isn't mentioned in this post.
1. Will the rear flange bolt right up to the rear-end? Or should I reuse the one on the old D/S?
2. What U-Joints should I use? Aerostar U-Joints or Mustang U-Joints?
3. The yoke (that goes in to the tranny) has 27 splines, Do I need to use the old one or is this one fine?
Thanks.
Once again Aluminum Drive Shaft off a 1996 AWD Aerostar.