well around here when we put block heaters on a motor we knock the old one one, sometimes it falls into the block (no biggie) and we thread the block heater in. now i think puting a new freeze plug is the same just press it in and its done.
Depends on how hard it is to get a straight shot at it. Those freeze plugs need to be hammered into place. Pulling it is no biggie. Getting the new one in can be a nightmare.
I just finished the job. I am sitting here with oil still on my forearms. The easiest way for me was to pull the headers off from the top and just reach in a replce them. I got the rubber ones where you push them in flush and then tighten the 1/2 inch screw to make them seal. Not that difficult. The only hard part is to find a way to leveragea prue bar into the engince compartment to flush mount the plugs.