I'm going to install my gauge senders (Oil Pressure, Water Temp, Oil Temp and Fuel Pressure) this weekend, but I'm not sure what thread size cross fitting for the oil pressure sender I should get, because I'm going to keep my stock gauge and I need to feed my supercharger.
The water temp I'm going to put in the stock location and move the stock one to the back of the intake, does it just thread in with the adapter that comes with the gauge?
For the oil temp sender I'm going to rethread the adapter so it threads on to one of my drain plug holes. I read on here someone did it and didn't have any problems or leaks has anyone else tried it?
And for the fuel pressure, my car has a gauge already installed under the hood installed on the schrader valve, Im going to install a tee onto it so I can also keep the under the hood gauge. What size are the threads on the schrader valve?
Sorry I suck at thread sizes.
Thanks Todd
The water temp I'm going to put in the stock location and move the stock one to the back of the intake, does it just thread in with the adapter that comes with the gauge?
For the oil temp sender I'm going to rethread the adapter so it threads on to one of my drain plug holes. I read on here someone did it and didn't have any problems or leaks has anyone else tried it?
And for the fuel pressure, my car has a gauge already installed under the hood installed on the schrader valve, Im going to install a tee onto it so I can also keep the under the hood gauge. What size are the threads on the schrader valve?
Sorry I suck at thread sizes.
Thanks Todd