Having trouble filling gas tank full

im going to be putting my car in teh back yard to pull the engine and replace the seals. maybe while its back there ill see what i can do with some brass tubing i have in teh back yard.. would brass be ok to use? also i will probably rivit it cause im lazy haha..

but i will probably crush the end of the tub into a flat oval shape to help keep it out of the way... and bend it by hand.. haha

i hope it works, if not ill ship it out to you, car is a 67 mercury cougar.
 
That sounds like a good idea 1320. I can take some pics of the filler nozzles around here and post them. You should make up a drawing of what your thinking of doing and post it up here or if you dont want anyone to take your idea you could PM me a drawing.
 
Size of the tank?

Mine does the same thing ( The gauge only goes 3/4 when full), but I was always under the impression that what is causing this is the fact that I have a 12 gallon tank oppose to the 16 gallon tank thinking the gauge is only made for a 16 gallon tank.
 
No pics, making it isn't the problem, it's making it to where it can be installed and won't come loose and fall into the tank. Basically think of a tube inside the fill tube that would stick through the opening on the tank and curve up once inside the tank, up past the tube flange.
 
My plan of attack is a bit different. I am not worried about Concours so..... I plan on cutting the factory neck on the inside and adding another neck in the trunk be brazing the two together. This will be done in a fashion that the "new" neck can be removed to allow the entire neck to be removed from the car as normal. This will actually require the use of two pieces of rubber hose and clamps. Once done, the filler neck inside the trunk will actually stand almost straight up and should be lower than the neck on the outside. This is to prevent overfill. The inside neck will have a NON VENTED cap to prevent fumes in the trunk. Venting will be thru the factory cap. To fill, just pop the trunk and it is pretty much a staight in shot for a fast fill. Now, just have to park it long enough to get it done.