Head Gasket blown??

leon_reynolds

Founding Member
Apr 24, 2002
91
0
6
I just finished putting on a set of world heads and an edelbrock performer upper and lower. Ran the car for a day and it started to get hot....let it cool and checked fluid and it was ok but started without cap on and it is bubbling a little and overflowing. There is also white smoke coming out the exaust so I did a pressure test on the cooling system to see if it would leak down but it held like a champ. I am fairly certain I blew the heads, but is there anything else I should check to make sure that is the problem......no milkshake under filler cap yet or fluid in oil......what next? thanks
 
I let it sit for 10 minutes with no drop in pressure. If it holds pressure and the head gaskets are ok, where else could I be getting antifreeze in my engine.....there is still white smoke......and it is overheating when running. Thanks
 
it seems wierd to me that a cooling system would hold pressure if a Head Gasket was blown. How much white smoke are we talking about? as for over heating was the system burped properly? Are you getting a flow through your top rad hose? was the water pump changed? (if so was it a reverse flow) thermo stat sticking? are you checking the temp with the factory gauge or do you have a aftermarket piece in?
 
Try checking the TB/EGR gasket first, and then check the Lower manifold to engine block gaskets. Also check and make sure you put the thermostat in correctly.