Lol...
We'll get another of these threads - http://mustangforums.com/forum/5-0l-general-discussion/368307-im-done-with-this-car.html
Me personally I always put a "smeared with my finger" amount of RTV around the intake and head sides of the intake gasket. Only exception would be NEW heads and NEW intake. And I'd still consider it. I run a circle around the head port, down and make the end seal out of goo, and up and around the other side head port as well. Put the gasket on and put the intake down slowly. Just me and my technique. 20yrs at a dealer and never gave me an issue.
Again, you will get different opinions on that. I've always taken a small amount of RTV and put it around the water jackets. Some builders say put them on dry. IF nothing else it helps the intake gasket from slipping. I also put a glob in each corner of the end rails where the rubber end pieces go..