• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Help for the Four-eyed guy

  • Thread starter Thread starter 98Fauxbra
  • Start date Start date Mar 22, 2006
9

98Fauxbra

Member
Jan 12, 2003
74
0
7
Hotlanta, GA.
Mar 22, 2006
#1
  • Mar 22, 2006
  • #1
Hey Guys,

Well, the income tax money is back and it is time to play! I have decided to get my 85 McLaren Ragtop back on the road after a two year hiatus. Here is my problem. This car is a 5.0 automatic and it is burdened with CFI. This car will start up and run just fine. Then while at a stop light it will die for no reason. It will start right back up but will not hold an idle. I want to change to a carb so that I can keep the appearance close to original. Will a 600 cfm holley with an electric choke fit on my stock manifold? Would I even want to attempt this or just go with an edelbrock performer? What do I need to do with the fuel pump or lack there of? Do I need to change the in-tank pump? Is there an in-tank pump? Also, can I rig the throttle linkage to work or is there an adapter that I can purchase? I am not out to make this car a street beast or even hit the drag strip with it. I just want a nice cruising car that will run and idle when I want it to. Is there anything I am missing? Any advice would be greatly appreciated. Thanks!

Bryan
 
D

Daggar

New Member
Jul 19, 2004
3,902
5
0
Mar 22, 2006
#2
  • Mar 22, 2006
  • #2
If you go with a Carb, you can get a pump to replace your current one. They're available in both internal and external so you can choose the style pump/pickup you like best. You may need to add a fuel line for a carb setup. Carb fuel supply is low pressure/high volume and the inside diameter of your stock fuel line may not support this. Other folks have installed a regulator inside of the engine bay that converts the high pressure, high volume, fuel supply into a low pressure one. It uses your current fuel pump. Most I've talked to say that this is not the right way to do it but that it does work.

If it were me....
I recently discovered the existance of a Multi-Port throttle body injection system from Holley that looks bad as hell. Had I known about it prior purchasing all the MAF stuff that I have now. Be forewarned... if you're clueless about tuning, you may want to ensure that you have someone on hand that DOES know tuning before you get elbow deep into a system like that.

Good Luck
 
9

95GTAODE

New Member
Nov 25, 2004
200
2
0
Mar 22, 2006
#3
  • Mar 22, 2006
  • #3
CFI cars usually have 2 pumps... A low preassure 6 PSI in-tank pump, and a high pressure frame mounted pump. If yours is not a late build with the single in-tank pump, you can remove the frame mounted one and replace it with a chunk of rubber fuel line.

You will have to replace the intake(Reccomend '83-'85 stock, Performer RPM or Weiand stealth, stay away from the Performer), you will also need a Duraspark module and a Duraspark dizzy from any '74-'84 carbed 302. The throttle cable is the same as for a carbed car, so you're good there, but the TV cable will need some creative tweaking, or just use the TV cable available from Lokar that is designed for an AOD with a carb.(What I did, worked great!)

You can ditch the computer and most of it's wiring harness, go here: www.jason.fletcher.net, for details on what wires you need to keep.
 
9

98Fauxbra

Member
Jan 12, 2003
74
0
7
Hotlanta, GA.
Mar 23, 2006
#4
  • Mar 23, 2006
  • #4
Before I go through all of the hassle, do you think that my fuel pump(s) might be at fault? I might get a f/p gauge and monitor that. Thanks for your replies!
 
You must log in or register to reply here.

Similar threads

Electrical problem plug in the drivers kick panel
  • Mindseye007
  • Aug 16, 2026
  • Fox 5.0 Mustang Tech
Replies
3
Views
242
Fox 5.0 Mustang Tech Aug 16, 2026
Mindseye007
Engine New factory manifold no start
  • Fishnchips
  • Oct 15, 2026
  • 1994 - 1995 Specific Tech
Replies
13
Views
415
1994 - 1995 Specific Tech Oct 22, 2026
DadLife0724
B
Electrical Why does my fox body keep frying eecs
  • brandyn200
  • Jun 20, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
527
Fox 5.0 Mustang Tech Jun 25, 2026
AeroCoupe
M
01 mustang 3.8 fuel pressure issue
  • Mhaley2006
  • May 29, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
4
Views
537
1996 - 2004 SN95 Mustang -General/Talk- Aug 9, 2026
JohnKay
J
C
Engine Idle cuts out
  • claypoolxx
  • Mar 7, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
25
Views
1K
Fox 5.0 Mustang Tech Jul 24, 2026
alutwon
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?