Ive searched and searched and found some awesome info, but non covering two things Ive uncovered while tryin to install some roller rockers on my mustang.
We did a set of early trick flow twisted wedge heads and got some Crane Gold roller rockers to go with it. They are pedestal mount. The passenger side went smooth, took 2 thick shims and all was well. Got to the drivers side and as we would start to torque the bolt, the valve would start opening. We shimmed some more and finally got it to stop, but it took 2 thicks and 1 somtimes 2 thin shims to work. Is that right or is somethin up? Another thing I wasnt sure of and need help on is the lifter. The motor has no oil in it and hasnt run in a week...is it ok to set these things with no oil in the lifters at all or should I add oil, prime the system then go again? I appreciate any help guys...I just wanna get this thing runnin again!
Matt
We did a set of early trick flow twisted wedge heads and got some Crane Gold roller rockers to go with it. They are pedestal mount. The passenger side went smooth, took 2 thick shims and all was well. Got to the drivers side and as we would start to torque the bolt, the valve would start opening. We shimmed some more and finally got it to stop, but it took 2 thicks and 1 somtimes 2 thin shims to work. Is that right or is somethin up? Another thing I wasnt sure of and need help on is the lifter. The motor has no oil in it and hasnt run in a week...is it ok to set these things with no oil in the lifters at all or should I add oil, prime the system then go again? I appreciate any help guys...I just wanna get this thing runnin again!
Matt