Hissin?

When you say that the negative battery connection is unhooked, do you mean the negative battery cable is literally unhooked (from the battery) or that the controller's ground wire is disconnected from the negative battery cable?


Was the fan unplugged during programming?

Does the fan work with the AC turned on?
 
The neg. battery terminal was un-hooked. I haven't started the car yet. I was checking my key on ignition source.

I would reconnect the cable and then take your meter and go over all of your connections. Something should be amiss. If so (or in addition) I'd send the Spal folks an email about it too. I recall the programming being kinda finicky and I'm not super-well versed in it.

Good luck.
 
Put everything on, got the car off the jack stands. started right up. added antifreez etc. Fan will not come on.

I have some experience to help me tomorrow install my gauges, tach and troubleshoot this friggin mess w/the controller.

His, of the 2 wires going to the charcoal canister which is hot? they are both black?
 
Hissin, I DID IT!!!!!!!!!!:banana:

I tapped the wrong wire going to the charcoal canister. One read very low and the other read 12V with the key on. So I switched that wire to my orange on that Spal.

I am soooo happy!:D

Thanks for all your help! Couldn't of done it without you man!