I have a Holley 4160 on my 302 that's less than 2 years old. I bought it brand new from summit about a year and a half ago. To this point I haven't had any problems with it. However last weekend I was having starting issues. It would start run fine for awhile and then bog, and idle roughly and eventually die. I tried restarting it with no luck. I figured I had flooded it while attempting to start it so I let it sit for a few hours. Later I was able to start it and it seemed to be doing ok.
Now today I went out and it started fine. However after a few minutes the same symptoms returned. While it was running poorly I took off the air cleaner to notice that my secondaries were leaking (dripping) at idle. I shut it off for a little while and went inside. When I came back it started fine and the secondaries weren't leaking. But, once it had been idling for awhile they began to start dripping again.
The first time this happened last week I noticed fuel dripping from underneath the diaphragm onto the intake as well.
So my secondaries are leaking at idle, what could be the problem?
Now today I went out and it started fine. However after a few minutes the same symptoms returned. While it was running poorly I took off the air cleaner to notice that my secondaries were leaking (dripping) at idle. I shut it off for a little while and went inside. When I came back it started fine and the secondaries weren't leaking. But, once it had been idling for awhile they began to start dripping again.
The first time this happened last week I noticed fuel dripping from underneath the diaphragm onto the intake as well.
So my secondaries are leaking at idle, what could be the problem?