horrible vibration/shaking

Allpro_5.0

New Member
Jan 10, 2007
5
0
0
yesterday i decided it was time for a brake over haul. so i replaced my front rotors, my drums, pads and shoes. while i was at it i put in new inner and outer wheel bearings on the front (possible suspects). and yesterday morning the car ran smoothly but i completed the job got everything together and now when i get up to about 60mph my whole cars starts vibrating real hard. it wont do it until i hit 60. i cant tell if its from the front the whole car seems to be just shaking. any suggestions?
 
lock nut?

im not sure but maybe you didnt tighten the nut on the outside of the rotor enough? i know from the factory you can take them off with your fingers. the not designed to be locked down hard. but i imagine not enough could cause vibration.
 
i checked

i thought about the nut so i took the cover off and made sure it was snug but not to tight and its still doing it. and i dont think its my drive shaft because it wasnt doing it earlier that day it started after i did the brake job.
 
What procedure did you use for torquing down the lock nuts? I'd retorque them, they might have come loose after driving.

Check your driveshaft bolts too, they can come loose pretty much out of nowhere. I had a horrible vibration above 50 mph that just came out of the blue one day. One shop told me I had a bad rear wheel bearing and another told me I'd bent a rear wheel. Turned out the driveshaft bolts had backed out nearly all the way. I tightened them down and no more vibration.
 
torque

i dont think you can torque them past a certain point because that retaining pin has to go in between the sleeve, nut and the spindle the hole has to line up. and i dont think they are gonna make another half turn to get it to the other side to put the pin through.
 
the nuts

make sure your rotors are pushed all the way up as to where the seal goes over that little lip and is all the way up against the spindle. cause its a pretty tight fit and if its not all the way up you will have play in it. and im not sure if you can tighten the nut down to hard as you mentioned. i would like to know that myself, maybe someone will chime in and let me know.