• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

i have a check engine light issue

  • Thread starter Thread starter nakednipple
  • Start date Start date Apr 20, 2006
  • 1
  • 2
Next
1 of 2 Next Last
N

nakednipple

New Member
Apr 18, 2005
82
0
0
Apr 20, 2006
#1
  • Apr 20, 2006
  • #1
my check engine light came on from chaing my exhaust, which i knew this would happen because i put on a catless exhaust with out any 02 deletes to stop the codes. ok so then my codes came on right and i had them checked just for my own peace of mind and it read mass air flow meter along with a few 02 sensor codes. so i relpaced the mass air flow sensor and put on so 02 deletes and had the ligh turned off again so i didnt have to wait for it to go off it's self. then later that next day it came back on.. had it checked again and it was mass air flow meter again !!!! but no 02 sensor codes... so that part is good but what the hell is wrong with my air flow meter... ( i had the whole unit changed..) i dont know what it is...i did a whole tune up before i decided to change my air flow meter just in case what was happening could be contributed to that.. any ideas?

thanks
 

Dope 97GT

New Member
Jul 16, 2005
439
0
0
Rochester, NY (SUNY Brockport)
Apr 20, 2006
#2
  • Apr 20, 2006
  • #2
maybe try cleaning the MAF sensor...something may have gotten onto it and got it dirty.

http://www.bullittarchive.com/1007.htm
 

sgarlic

Founding Member
Apr 21, 2001
3,085
1
56
Apr 20, 2006
#3
  • Apr 20, 2006
  • #3
What's the code?
 

tomustang

Psychotic Member
Founding Member
Jun 8, 2000
3,434
2
78
McLean Hospital
Apr 20, 2006
#4
  • Apr 20, 2006
  • #4
 

03ghoststang

Well-Known Member
Jul 16, 2005
1,930
1
57
Los Angeles, California
Apr 20, 2006
#5
  • Apr 20, 2006
  • #5
yeah i also agree what where teh codes???
 
N

nakednipple

New Member
Apr 18, 2005
82
0
0
Apr 20, 2006
#6
  • Apr 20, 2006
  • #6
it just said mass air meter
 
N

nakednipple

New Member
Apr 18, 2005
82
0
0
Apr 20, 2006
#7
  • Apr 20, 2006
  • #7
it just read mass air meter ..
 

BlackGT4.6

New Member
Jun 15, 2005
103
0
0
In.
Apr 20, 2006
#8
  • Apr 20, 2006
  • #8
do you have a k&n filter if so the oil may be getting in the maf
 

85 Coupe 5.0

Founding Member
Dec 18, 2001
817
2
16
Kansas
Apr 20, 2006
#9
  • Apr 20, 2006
  • #9
+1 on the K&N oil..........

We need a code number please..........

There are like 3 or so Mass Air codes, please be specific.

Good one TOM
 
D

Dragstr05

New Member
Dec 21, 2004
643
1
0
Stafford VA
Apr 20, 2006
#10
  • Apr 20, 2006
  • #10
Having a code that has to do with the MAF and then just replacing the MAF doesnt necessarily mean you actually fixed the problem. There may have been nothing wrong at all with the unit, but you replaced it. You need to be sure the whole circuit is good too. Would help to know what the code was.
 
N

nakednipple

New Member
Apr 18, 2005
82
0
0
Apr 21, 2006
#11
  • Apr 21, 2006
  • #11
sorry for my stupidity the code is P1132 and the ticket autozone printed for me reads "Lack of HO2S switch- sensor indicates rich"

i have 02 deletes on the car and no o2 codes are flashed

thanks for your help
 

sgarlic

Founding Member
Apr 21, 2001
3,085
1
56
Apr 21, 2006
#12
  • Apr 21, 2006
  • #12
Ok, wait a second. That code isn't necessarily MAF related.

After reading your first post again, you said one of your codes without MIL elims was MAF related. If you're talking about the P1132 code, I'd say that's o2 sensor wiring related.

When you swapped midpipes, did you have to extend the drivers side o2 sensor wiring? If so, recheck it. Also, I'd double check the o2 sensors themselves for tightness, and check the wiring of all 4 sensors for burns.
 
N

nakednipple

New Member
Apr 18, 2005
82
0
0
Apr 21, 2006
#13
  • Apr 21, 2006
  • #13
hmm... you have a nice point there.. what i ment to say is when i changed the mid pipe i knew id throw codes ( cuz i hadnt bought my MIL yet) so i did it and it threw a code (expected) id figured it would be all 02 related ( there is where my stupidity shows) so i replace the MAS sensor when it threw that code, and put on my MIL's. went to autozone had them turn off the codes and it came on the next day after like 15-20 of driving. had it checked again at autozone and all the 02 codes are gone and the MAS P1132 is there... had it turned off AGAIN and it came back AGAIN...

P.S-- i had to replace one of my o2 sensors b/c it broke while installing the midpipe.... (i drove around with a broke 02 sensor for about a month or so until i replaced it after doing the MAS sensor -and obviously before the MIL's)

you say its the wires maybe? it couldnt be the fact that one 02 is new and the other old could it? how should i pin point it to wires?

thanks !
 
N

nakednipple

New Member
Apr 18, 2005
82
0
0
Apr 22, 2006
#14
  • Apr 22, 2006
  • #14
so that code can not have anything to do with the actual reading of the 0s b/c i have mils on there, so it has to be wiring?
 
N

nakednipple

New Member
Apr 18, 2005
82
0
0
Apr 22, 2006
#15
  • Apr 22, 2006
  • #15
bump
 

Mike97gt

it doe snot
Founding Member
Jan 26, 1999
10,633
7
89
the people's republic of massachusetts
Apr 23, 2006
#16
  • Apr 23, 2006
  • #16
ok I see a little confusion going on in this thread and I have to jump in and clear it up

that code p1132 is for bank 1 upstream 02 sensor lack of switch sensor indiactes rich.

this has NOTHING to do with your mil elims, the mil elims have nothing to do wiht the upstream 02's ( the sensors closest to the manifolds) the mile elims connect to the rear monitor 02's


find a way to get live data and look at the long term fuel trims for bank 1 and bank2 and report back.
 
N

nakednipple

New Member
Apr 18, 2005
82
0
0
Apr 23, 2006
#17
  • Apr 23, 2006
  • #17
so what do you advice i do in order to clear it up? i have to get it inspected by may 1st or i get fined
 
N

nakednipple

New Member
Apr 18, 2005
82
0
0
Apr 23, 2006
#18
  • Apr 23, 2006
  • #18
so what do you think i should i do about my car, because i have to get it inspected by may 1st or i get fined!
 
N

nakednipple

New Member
Apr 18, 2005
82
0
0
Apr 23, 2006
#19
  • Apr 23, 2006
  • #19
what do you suggest i do i have to get my car inspected by may 1st or i face a fine.
 

Mike97gt

it doe snot
Founding Member
Jan 26, 1999
10,633
7
89
the people's republic of massachusetts
Apr 23, 2006
#20
  • Apr 23, 2006
  • #20
well i need the live data info I asked for to try and point you in the right direction. it's impossible to diag this stuff with no info.
 
  • 1
  • 2
Next
1 of 2 Next Last
You must log in or register to reply here.

Similar threads

S
07 v6 4.0 wiring issue .In desperate need of help.
  • Staycstang
  • Sep 19, 2025
  • 2005 - 2014 Specific V6 Tech
Replies
1
Views
328
2005 - 2014 Specific V6 Tech Sep 19, 2025
Noobz347
7
Engine Random hanging idle
  • 706 Saleen
  • Feb 11, 2026
  • Fox 5.0 Mustang Tech
Replies
9
Views
445
Fox 5.0 Mustang Tech Feb 19, 2026
86HO5.0
8
M
Help! 2003 GT misfire when hot
  • Modular03
  • Feb 10, 2026
  • SN95 4.6L Mustang Tech
Replies
4
Views
317
SN95 4.6L Mustang Tech Feb 13, 2026
Mustang5L5
P
2000 GT Random Power Loss
  • Pinellas50
  • Mar 9, 2026
  • SN95 4.6L Mustang Tech
Replies
4
Views
245
SN95 4.6L Mustang Tech Mar 23, 2026
Pinellas50
P
1
Engine 91 mustang 302 Low acceleration car backfires pops and acts like it doesn’t want to take fuel
  • 1991Fox5.0
  • Oct 4, 2025
  • Fox 5.0 Mustang Tech
Replies
16
Views
949
Fox 5.0 Mustang Tech Oct 6, 2025
1991Fox5.0
1
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?