Well I'm just excited to finally start the final stages of my build (six year process
1989 4 cyl notch
IMHO a Badass two tone paint job
custom interior all black painless switch panel kirkey race seats
12 point cage painted to match car torque boxes and sub frames welded
all wolfe race craft rear susp, 8.8 TA girdle, 4:10, 33-spline pro race
all PA racing front end tubular K member, A-arms, AJE coil over BBK Cast/Camber
strange 10-way adjus all 4 corners
C-4 done up by local shop billet servo good clutches
4500 coan stall
chetah shifter
wheels and tires
centerline telstars 15x4 & 15x10
28x10.5 ET DRAG & some 315's MT radials
Now for the good stuff
69 351w (408) 11:1 all eagle 4340 internals 2000 bolt option
girdle,canton oil pan
JE pistons
AFR 205 nitrous port option
ED curtis solid roller tight lash
ported 351w victor junior
csr water pump
130 amp alt
crower link bar lifters
comp pro magnum rockers
rocker stud girdle
kooks 1 7/8 to 3.5 headers dr gas 3" X pipe & bassani or bullets for mufflers
pro systems custom 870 cfm carb
NX express Hitman
Barry Grant 280 pump sumped tank 1/2" line BG fuel pre reg
hope to drive it on the street and be done by may or june still @ chasis shop and then finish interior and other little stuff like going to work and spending time with the family....LOL
so it should be a low 12 sec or high 11 sec car?...
1989 4 cyl notch
IMHO a Badass two tone paint job
custom interior all black painless switch panel kirkey race seats
12 point cage painted to match car torque boxes and sub frames welded
all wolfe race craft rear susp, 8.8 TA girdle, 4:10, 33-spline pro race
all PA racing front end tubular K member, A-arms, AJE coil over BBK Cast/Camber
strange 10-way adjus all 4 corners
C-4 done up by local shop billet servo good clutches
4500 coan stall
chetah shifter
wheels and tires
centerline telstars 15x4 & 15x10
28x10.5 ET DRAG & some 315's MT radials
Now for the good stuff
69 351w (408) 11:1 all eagle 4340 internals 2000 bolt option
girdle,canton oil pan
JE pistons
AFR 205 nitrous port option
ED curtis solid roller tight lash
ported 351w victor junior
csr water pump
130 amp alt
crower link bar lifters
comp pro magnum rockers
rocker stud girdle
kooks 1 7/8 to 3.5 headers dr gas 3" X pipe & bassani or bullets for mufflers
pro systems custom 870 cfm carb
NX express Hitman
Barry Grant 280 pump sumped tank 1/2" line BG fuel pre reg
hope to drive it on the street and be done by may or june still @ chasis shop and then finish interior and other little stuff like going to work and spending time with the family....LOL
so it should be a low 12 sec or high 11 sec car?...