• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-

In need of some help

  • Thread starter Thread starter brignutz
  • Start date Start date Jul 19, 2006
B

brignutz

New Member
Jul 12, 2006
0
0
0
Jul 19, 2006
#1
  • Jul 19, 2006
  • #1
Hey guys I just bought a 1987 mustang LX Convertible for a project and i can't get it to start my plugs and wires are new and i just put in a new ignition coild and ideas on what my problem may be or was there a comon problem in this year of mustang...thanks for your help..Brignutz:SNSign:
 
R

RustBucket

New Member
Jun 8, 2003
585
0
0
Buford, GA
Jul 19, 2006
#2
  • Jul 19, 2006
  • #2
Is the timing belt OK?
 

Red_LX

I’m not much help unless you’re looking for ****!
Founding Member
Nov 29, 1999
5,896
73
129
Morgantown, WV...where couches meet their doom
Jul 19, 2006
#3
  • Jul 19, 2006
  • #3
Yep check timing belt, and/or try replacing the TFI module or swapping out the whole distributor. Could also pull the distributor cap and make sure it and the rotor are alright.
 

stykthyn

I want to measure mine. It doesn't look that tall.
15 Year Member
Jul 6, 2006
5,232
2,652
223
gainesville
Jul 19, 2006
#4
  • Jul 19, 2006
  • #4
post some pics of your vert, I just bought a 93 last week. finally got that biotch running right. Now I just gotta wrestle a new top on that thing
 

Jquintel

Member
Jun 8, 2003
194
0
16
Fort Wayne, IN
Jul 20, 2006
#5
  • Jul 20, 2006
  • #5
also if you havent already make sure your fuel pump is turning on, when you turn your ignition on
 
B

brignutz

New Member
Jul 12, 2006
0
0
0
Jul 21, 2006
#6
  • Jul 21, 2006
  • #6
RustBucket said:
Is the timing belt OK?
Click to expand...
yeah i think so this is my first car but i have been around them my whole likfe working on the and i can't seem to figure out what this is it will crank cvontinuously but will not fire
 

Jquintel

Member
Jun 8, 2003
194
0
16
Fort Wayne, IN
Jul 22, 2006
#7
  • Jul 22, 2006
  • #7
brignutz said:
yeah i think so this is my first car but i have been around them my whole likfe working on the and i can't seem to figure out what this is it will crank cvontinuously but will not fire
Click to expand...
if you can, just gently open the timing cover, if you can see your gear, with no belt, its your Timing belt, takes like 3 mins to check
 
R

RustBucket

New Member
Jun 8, 2003
585
0
0
Buford, GA
Jul 22, 2006
#8
  • Jul 22, 2006
  • #8
That's not always a good indicator of a bad timing belt. Sometimes just the belt teeth around the crank pulley get wiped off. The belt will still be intact, but no worky. You're right in the fact that it only takes a minute or two and is worth verifying. I'd rather he come back and post "I know" it's bad rather than "I think". Ya know?
 
J

jims92mustanglx

New Member
Jul 12, 2006
14
0
0
craigville indiana
Jul 22, 2006
#9
  • Jul 22, 2006
  • #9
have you confirmed that you have spark. if you do then you need to make sure you get fuel. ,when you turn the ignition key to on position you should here the fuel pump kick in , its at the rear of the car. if its working, you need to check and make sure its getting air into the motor. sometimes the intake right at the manifold will clog not letting any air in. good luck
 
J

JosephB

New Member
May 2, 2006
42
0
0
Alabama...for now.
Jul 22, 2006
#10
  • Jul 22, 2006
  • #10
Air, Fuel, Fire
Check the air filter
Check fuel pressure at the rail
Check for spark with plug element touching ground
If these are good, check compression
Then narrow it down from there
 
G

glorkar

New Member
Nov 10, 2002
109
0
0
Oshkosh, WI
Jul 23, 2006
#11
  • Jul 23, 2006
  • #11
May be a dumb question, but have you checked the inertia switch in the trunk?
 
You must log in or register to reply here.

Similar threads

M
85 mustang 5.0 cranking in run position
  • Mamaclean
  • May 23, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
184
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 1, 2026
General karthief
C
C4 trans help needed
  • CPH89LX
  • Apr 26, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
6
Views
282
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Apr 28, 2026
CPH89LX
C
9
1994 Mustang GT 5.0 L Convertible
  • 94ns95
  • Jun 17, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
10
Views
289
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 19, 2026
94ns95
9
Problems after exhaust install and 02 harness
  • djj62478
  • Jul 2, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
39
Views
703
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 18, 2026
AeroCoupe
F
86 notch NEED HELP!!!!
  • foxbody86
  • Jul 8, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
2
Views
124
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 9, 2026
Noobz347
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?