Installing wideband, questions?

jabGT

New Member
Mar 11, 2004
59
0
0
Michigan
Its a zeitronix wideband. Where is the best place to tap to get TPS, RPM, and ground. Will it be easier to tap into the harness going into the ECU (if possible) or should I go from the wires coming of the sensor and tach? What is a good place to find 12V switched power? Thanks for the help.
 
12 volt switched power can be had from the fuse panel with the largest fuse (if your wideband heats up the sensor then this is important). As for tapping into an RPM location... I wouldn't do either one. Instead, wrap copper wire around your coil wire, plug the end into your RPM converter and make it look pretty. It's a poor man's inductive pickup and will reduce RPM spikes.