• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Intermitant Electrical Problem

  • Thread starter Thread starter bigguy14
  • Start date Start date Apr 2, 2006
B

bigguy14

New Member
Jun 5, 2002
2
0
1
Apr 2, 2006
#1
  • Apr 2, 2006
  • #1
Hi I have a 89 5.0, mostly stock. I am having some troubles with the electrical and was wondering if anyone could give me some tips on how to fix it.

It all started with a problem with my alternator. That has been replaced and so has the battery. But now when I test from + on the battery to the frame I get 0volts and - to frame I get 12volts. Which would tell me that I have a short somewhere. I have checked everything and there is nothing visible that is shorting so now I am thinking there is a relay or something that is fried. I can remove the yellow lead with the fuse links going to the cab of the car from the solenoid and the short goes away. Now the strange thing is if I connect a battery charger directly to the yellow lead sometimes everything powers up and sometimes it doesn't. If it does I can then connect the lead back up to the car and it will crank over and work like normal for a few seconds. Then it starts all over again. I have replaced the solenoid once already. I can disconnect the ignition module from the steering colume and it doesn't change a thing. I have no power to the dome light or the hood light or anything inside the car when it quits.

I have done alot of thing so I may have missed mentioning them here but I welcome any and all ideas.

Thanks.
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Apr 2, 2006
#2
  • Apr 2, 2006
  • #2
Sounds like bad cable or bad connection. Check and clean all the
battery connections. If you have battery terminals that clamp on
the wire with two bolts, get rid of them and get some real
battery cables made for your car.


Grounds are important to any electrical system, and especially to
computers.

1.) The main power ground is from engine block to battery: it is
the power ground for the starter & alternator.

2.) The secondary power ground is between the back of the
intake manifold and the driver's side firewall. It is often missing or
loose. It supplies ground for the alternator, A/C compressor
clutch and other electrical accessories such as the gauges.
Any car that has a 3G alternator needs a 4 gauge ground wire
running from the block to the chassis ground where the battery
pigtail ground connects.
The 3G has a 130 amp capacity, so
you wire the power side with 4 gauge wire. It stands to reason
that the ground side handles just a much current, so it needs to
be 4 gauge too.

Picture courtesy timewarped1972

3.) The computer has its own dedicated power ground that
comes off the ground pigtail on the battery ground wire. Due to
it's proximity to the battery, it may become corroded by acid
fumes from the battery. It is a black cylinder about 2 1/2" long
by 1" diameter with a black/lt green wire.You'll find it up next to
the starter solenoid where the wire goes into the wiring harness


4.) All the sensors have a common separate ground. This
includes the TPS, ACT, EGE, BAP, & VSS sensors.

5.) The O2 sensor heaters have their own ground (HEGO ground)
coming from the computer. This is different and separate from
the O2 sensor ground. It is in the fuel injector wiring harness and
comes out under the throttle body. It gets connected to a
manifold or head bolt.

6.) The TFI module has 2 grounds: one for the foil shield around
the wires and another for the module itself. The TFI module
ground terminates inside the computer.

7.) The computer takes the shield ground for the TFI module and
runs it from pin 20 to the chassis near the computer.

8.) The computer's main power ground (the one that comes from
the battery ground wire) uses pins 40 & 60 for all the things it
controls internally.

See http://www.fluke.com/application_notes/automotive/circuit.asp?AGID=1&SID=103#volt
for help troubleshooting voltage drops across grounds

Extra grounds are like the reserve parachute for a sky diver.
If the main one fails, there is always your reserve.

The best plan is to have all the grounds meet at one central spot
and connect together there. That eliminates any voltage drops
from grounds connected at different places. A voltage drop
between the computer ground and the alternator power ground will effectively reduce the voltage available to the computer by
the amount of the drop.
 

Attachments

  • ground.webp
    29.6 KB · Views: 184
You must log in or register to reply here.

Similar threads

S
Resolved 83 alternator wiring harness
  • sparten5000
  • Aug 2, 2026
  • Fox 5.0 Mustang Tech
Replies
2
Views
192
Fox 5.0 Mustang Tech Aug 23, 2026
limp
C
Electrical Fuel Gauge...Help! What did I do or Didn't Do?
  • ChickenDeluxe
  • Sep 3, 2026
  • Fox 5.0 Mustang Tech
Replies
2
Views
250
Fox 5.0 Mustang Tech Sep 3, 2026
ChickenDeluxe
C
T
Inside is completely dead
  • TunaCar
  • Oct 18, 2026
  • SN95 4.6L Mustang Tech
Replies
11
Views
354
SN95 4.6L Mustang Tech Oct 20, 2026
DadLife0724
Resolved Wiring electric fan
  • cbac89
  • Aug 29, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
240
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 30, 2026
cbac89
R
Engine Evap and charcoal cannister leak
  • ryan1994stang
  • Mar 14, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
664
Fox 5.0 Mustang Tech Mar 18, 2026
Mcmahst
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?