It Hot as Hell Down Here

I just finished installing my Equal lenght Shorties and while I had it all apart I basicly replaced my entire A/C system exept the evaporator because it's getting to that time of year when it 90 degrees 24 hours a day in South Florida....

The a/c has not worked in a while and I haven't really had much use for the heater down here so I go to turn the a/c on and it will only blow through the Defroster no matter were the selector is.......What do you think the problem is, I have not had a chance to dig into it to see what it could be..........Could it be the switch, or the "linkage" that moves the duct......anyone else have this problem.....I'll hopfully dig into it tomorrow, but I figured the all mighty stang-net might have some insight....

By the way Installing equal-lenght shorties on the drivers side with the compressor out was cake!!!! It just slides right in from the front....


It's a 94 cobra by the way...
 
Look at the vacuum lines that control the A/C. There is one on the vacuum tree for the A/C.
The vacuum tree is a funny looking multiple outlet for vacuum mounted behind the upper intake
manifold on the driver's side.

Diagram courtesy of Tmoss & Stang&2birds
Mustang_AC_heat_vacuum_controls.gif


See the following website for some help from Tmoss (diagram designer) & Stang&2Birds (website host) for help on 88-95 wiring http://www.veryuseful.com/mustang/tech/engine/

http://www.veryuseful.com/mustang/tech/engine/images/IgnitionSwitchWiring.gif

http://www.veryuseful.com/mustang/tech/engine/images/fuel-alt-links-ign-ac.gif

http://www.veryuseful.com/mustang/tech/engine/images/88-91_5.0_EEC_Wiring_Diagram.gif
 

Attachments

  • Mustang_AC_heat_vacuum_controls.gif
    Mustang_AC_heat_vacuum_controls.gif
    17.8 KB · Views: 148
You have a vacuum leak supplying the AC controls. The damper that switches from vents to defrost to heat is vacuum operated. Check all the lines from the vacuum tree by the booster to the passenger side under the hood, the lines under the dash to the controls, and the yellow line from the controls to the damper motor which is right above the accelerator pedal. It has a hole or has come loose somewhere along the way.


Edit: I see the expert was typing just as I was. LOL! Good luck on finding the leak!
 
The 94-95's are prone to having a line failure as the line transgresses the firewall (near the aforementioned tree and under the STB). IIRC it's the 3rd one down from the top at the vac tree (check it at the tree too - sometimes the rubber bootie goes south).

Good luck.
EDIT: here are some pics.