I just installed the accufab upper intake plenum and the accufab throttle body, i took off all the sensors and vaccum lines and plugged them back in, but when i put the tps back on i just threw it back on with out checking the voltage. we were trying to set the voltage but it wasnt reading anything, then the check engine light came on. right now it likes to hang a little bit around 2000 or 1500, it needs to be at .98 volts but how do you get it to .98 volts? just throw the tps sensor on and try to adjust it with the idle screw? do you need to adjust the tps BEFORE you put the sensor on?
does anyone have any pictures of how they did it or any good instructions on it? thanks
does anyone have any pictures of how they did it or any good instructions on it? thanks